Datacolor AutoLab SPS Quick-start Manual
AutoLab SPS Quick start manual TFSTARTMANSPS / Rev 2.0 / 1st Jul 2013 / Jeffery Fain Page 6 of 11
Step 3: Make sure target temperature on controller is correct. If not, change it by
following steps 4 to 6.
Step 4: Press the “SET” button once, the green LED display will flash.
Step 5: Press up/down button to set target temperature.
Step 6: Press “SET” again to finish temperature setting.
Step 7: Check if the hot water tank is full.
Step 8: Check if the “HEATER ON” button is on. If not, press it to switch it on.
Step 9: Waiting until the actual temperature is same as target temperature shown
on controller before stating making solution.
Step 10: Start the SPS program to initialize the system.
Target degrees
Actuality degrees
