Datalogic Magellan 1100i User manual

© 2009 - 2013 Datalogic ADC, Inc 820061314 (Rev. B) November 2013
Magellan
TM
1100i
Fixed Mounting Plate Instructions
Securing the Fixed Mounting Plate
This sturdy plate can be used to mount the scanner in a number of
positions; either for new installations or to add to an existing system.
llaWpotretnuoC
Under Counter
New Installation
1. Determine the mounting location. The plate allows flexible, yet sturdy
mounting to a countertop, table, wall, or even under a counter. While
deciding on the best position, you might want to keep in mind the
best way to route the scanner cable (you may need to drill a hole for
it).
2. Using two of the screws provided in the kit, securely fasten them
down through the plate in the position desired.
BSR idware GmbH
Jakob-Haringer-Str.3
A-5020 Salzburg
Web: www.bsr.at

© 2009 - 2013 Datalogic ADC, Inc 820061314 (Rev. B) November 2013
Existing Installation
For your convenience, the Fixed Mounting Plate has been designed to
mount to the same hole patterns that have already been drilled for a
scanner being replaced. Just push the new screws up through the existing
holes to secure the mounting plate in place of the old unit. If the screw
pattern doesn’t match, attach using the New Installation instructions.
Latching/Unlatching the Scanner
1. To latch, engage the front latches as shown in the “Latching” illustra-
tion, then rotate the rear of the scanner down onto the stand to
secure the scanner in the rear latch.
2. Unlatching: Grasp the scanner as shown and rotate the rear up and
away from the stand to disengage the rear latch, then the opposite
end away from the front latches.
Rear
Latch
Scanner
Rear
Latch
gnihctalnUgnihctaL
Front
Latches