decakila KUJB001W User manual

STAND BLENDERSTAND BLENDER
KUJB001WKUJB001W
P
0
1
2

BLENDER OPERATION
POWER CORD INFORMATION
WARNING
IMPORTANT SAFETY INSTRUCTIONS
CLEANING AND MAINTENANCE
ENVIRONMENT FRIENDLY DISPOSAL
01
03
03
04
05
05
CONTENTS

Read all instructions.
Before using check that the voltage indicated on the product corresponds with the voltage of your electrical outlet.
Do not let cord hang on hot surface or over edge of table or counter.
Do not operate any appliance with a damaged cord or plug or aer the appliance malfunction or has been damaged in any manner.
Return the appliance to the nearest authorized service facility for examination, repair or adjustment.
If the supply cord is damaged，it must be replaced by the manufacturer or its service agent or a similarly qualified person in order
to avoid a hazard.
Close supervision is necessary when any appliance is used by or near children.
Avoid contacting the moving parts.
Keep hands and utensils out of container while blending to reduce the risk of severe injury to persons or damage to the blender. A
scraper may be used but must be used only when the blender is not running.
The use of attachments not recommended or sold by manufacturer may cause fire, electric shock or injury.
Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. To disconnect, turn any control to “0”,
then remove plug from wall outlet by grasping the plug, not the cord.
To reduce the risk of injury, never place blade assembly on motor unit without the jar properly attached.
This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards
involved.
Children shall not play with the appliance.
Do not leave the machine on unattended.
When removing the blender from the motor unit, wait until the blades have completely stopped.
When using this electrical appliance, basic safety precautions should always be followed, including the following:
IMPORTANT SAFEGUARDS
01

Always operate blender with cover in place.
Always use the appliance on a secure, dry level surface.
Never place this appliance on or near a hot gas or an electric burner or where it could touch a heated appliance.
Do not use outdoors.
Do not use appliance for other than its intended use.
Do not operate without this cover in place;
Avoid any contact with blades or moveable parts.
Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.
Always disconnect the appliance from the supply if it is le unattended and before assembling, disassembling or cleaning.
Care shall be taken when handling the sharp cutting blades, emptying the bowl and during cleaning.
Be careful if hot liquid is poured into the appliance as it can be ejected out of the appliance due to a sudden steaming.
To protect against risk of electrical shock do not put (state specific part or parts in question) in water or other liquid.
The use of attachments, including canning jars, not the manufacturer may cause fire, electric shock or injury.
Do Not Blend Hot Liquids.
02

Check that all parts are complete and not damaged. Choose
the appropriate attachment to perform your desired task.
The blender attachment is suitable for blending fruits or
vegetables or crushing ice, while the grinder attachment for
grinding coffee beans. Clean the attachment according to the
section “CLEANING AND MAINTENANCE”.
WARNING: The blade is sharp, handle with great care and
ensure that unplug the appliance from outlet before assem-
bling and removing parts.
Lay the motor unit on the flat horizontal surface and make
sure it is unplugged.
NOTE: There is a safety interlock device at the bottom of jar,
if the jar is not assembled in place, the blender will not
operate.
BLENDER OPERATION
POWER CORD INFORMATION
This appliance has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this
plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not modify
the plug in any way.
03
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
Measure cup
Jar cover
Measure cup
Jar
Jar base seal ring
Jar base
Body
Switch botton
Base

NOTE: Make sure the jar cover is placed in position
completely before operating, and never open the jar cover
during operation.
Do not run the appliance for more than 2 minutes per time,
and only wait until the unit is cooled to room temperature
before performing next operation cycle.
Turn the Speed Selector to “ 0” position once the mixture has
been blended to your desired consistency.
Turn the jar anti-clockwise and remove it from the motor unit,
carefully take down the jar cover, then pour and serve.
Never operate the appliance continuously for more than 2
minutes per time.
Blades are very sharp. Handle with care.
Do not operate without the jar cover in place.
Do not disassemble the jar or bowl from the jar base or bowl
base in general condition.
04
WARNING
Open the jar cover by turning anticlockwise and place it on the
surface. Peel or core the fruits or vegetables and then cut it
into small pieces, then put them into the jar. Usually certain
amount of purified water has to be added to facilitate the
smooth running of appliance. The amount of mixture should
not exceed the max level as indicated on the jar, nor sit lower
the min level. The best proportion of the fruits or vegetables
and water is 2:3.
NOTE: The blender is not applicable for beating egg white,
mashing potatoes, mixing dough, extracting juice from fruit
and vegetable.
Replace jar cover on the jar and turn it clockwise.
NOTE: There is a safety interlock device at the side of jar
cover, if the jar cover is not assembled in place, the blender
will not operate.
You may add ingredients into the jar through the center
opening of jar cover during operation, then replace measuring
cup if necessary. Let the tabs of measuring cup aligns with the
grooves of jar cover, put down and turn the measuring cup by
clockwise until it in place.
Ensure the Speed Selector to “ 0” Position, then plug into
power outlet and set Speed Selector to your desired setting.
You can press down the Pulse button without releasing it if
want to accelerate the process of blending. The detailed
information is shown in below Fig. 1
Fig. 1

05
CLEANING AND MAINTENANCE
ENVIRONMENT
FRIENDLY DISPOSAL
You can help protect the environment!
Please remember to respect the local
regulations: hand in the non-working
electrical equipments to an appropriate
waste disposal centre.
This appliance can be used by children aged from 8 years old
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards
involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervi-
sion.
Blending maximum level load or hard fruits and vegetables
must be sure that the speed selector is setting at highest
speed (speed 2). If the speed is used too low, the motor will be
damaged due to insufficient torque. When the motor speed is
found to be too slow, you must immediately use a higher
speed setting to blend or turn the speed selector to “0” to stop
blend!
Make sure to disconnect appliance from power supply before
cleaning for blender.
The Auto Clean function can clean the blender easily and
rapidly in complete safety.
Pour a little warm soapy water into the Jar and turn the Speed
Selector to “1” position and press down the Pulse button
without releasing it for a few seconds.
Wipe the outer surface of motor unit and with a damp cloth.
NOTE: Do not use abrasive cleanser and never immerse motor
unit in water for cleaning
Dry all parts and then assemble them. The method of assembling
blender attachment just is in opposite of its detaching sequence.
NOTE: If any problem has been encountered during using,
never disassemble the Motor Unit by yourself. There are no
user serviceable parts inside. Only contact the authorized
service facility for examination and repair.

User guide
www.decakila.com Global Links Technology Co. Pte. Ltd.
Made in China Jiangsu China. 2021.D02
decakila decakila