Degritter RCM User manual

Degritter water level sensor cleaning guide
Requirements:
● Toothbrush
● Degritter RCM

1. Remove the rubber gasket
To remove the rubber gasket, gently push it towards the center of the record insertion slot.
Once the gasket is loosened you can pull it off the machine.

2. Locate sensor pins
When facing the machine look in side the ultrasonic tank and try to locate two metal pins sticking out at the
bottom of the tank. They are a bit to the left from the center of the tank.

3. Clean the sensor pins
Clean the sensor pins gently with a toothbrush. A small amount of Degritter’s cleaning fluid can be added to
the brushes. Once the pins are cleaned, brush them once more with a toothbrush rinsed in clean water.

4. Test the machine
Before putting back the rubber gasket, test the machine to verify that the sensor pins are clean and the
machine is able to pump out water normally.
5. Put back the gasket
Once the sensor works as intended, put back the rubber gasket.