DeLonghi EC250 User manual

лчиттничюнльтцию.
глтчн.Бзвыдны
www.sotmarket.ru
дбняинфмциятв,
тзывы,бзыиы
Инструкция для
Delonghi EC 250 B
Перейти в карточку товара
8 800 775 98 98

5713216671/06.11
De’Longhi Appliances
via Seitz, 47
31100 Treviso Italia

EC250
COFFEE MAKER
Instructions for use

2
Electrical connection (uk only)
Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your
home, if you are in any doubt about your supply contact your local electricity company.
The exible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.
Should this plug not t the socket outlets in your home, it should be cut o and replaced with a suitable plug, following
the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left
where children might nd it and plug it into a supply socket - with the obvious consequent danger.
Please note:We recommend the use of good quality plugs and wall sockets that can be switched o when the machine
is not in use.
IMPORTANT: The wires in the mains lead tted to this appliance are coloured in accordance with the following code:
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identi-
fying the terminals in your plug, proceed as follows:
- The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with
the letter E or by the earth symbol or coloured green or green and yellow.
- The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured
black.
- The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured
red.
When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten
the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt,
consult a qualied electrician.
Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualied electri-
cian and should only be replaced with a exible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be retted. If the fuse cover is lost, the plug must not be used
until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in
the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be tted.
This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.
Warning - this appliance must be earthed
Green and Yellow to Earth
13 amp
Fuse
Brown to
live
Cord Clamp
Blue to
neutral

3
! !-#"#"!-()$"!-,&,'*,+%Description

4
65
10
12
2
7
11
8
1
34
9
13
OK!
STOP
MAX
Open the lid and remove the water tank Fill the tank (do not pass the MAX level)
Reposition the tank
Plug the appliance in
Attach the lter holder
Push the button Turn the switch
Switch the appliance on Insert the empty lter
Place 2 empty containers Wait until light comes on
Once emptied
the water tank...
First use

5
16 17 18
14 15
READY!
Repeat
Steps 1 to 4
and
Steps 9 to 14
OFF
Carry out
steps (1-8)
Stop ow
Empty the cup
Empty the containers
Place a cup Fill the cup with hot water
Place the required lter in
the lter holder, then
proceed with making an
espresso (page 6)
Pre-heating the coee machine and cup

6
19
1 Espresso
2Espresso s
1-cup/
1-pod
coee lter
2-cups
coee lter
light
strong
EspressoReady!
STOP
FLOW
x2
normal
OK!
If you want lter to use coee quantity
Press the
coee
powder
according
to taste


Espresso

7
Makeanespresso
(page6)
20 21
22
5°C
max 1/3
OK!
23
60s Max.
STOP
24
Cappuccino Ready!
Cleaning
(page 8)
ON!
Push the button and wait for the light to come on
Open the steam switch
Position the container under
the cappuccino nozzle
Pour the frothed milk into the cups
containing the previously
prepared espresso coee.
For hygiene purposes always clean
the cappuccino nozzle after each use
It is recommended to use semi-skimmed
milk at refrigerator temperature.
Use about 100 grams
of milk for every cappuccino to be prepared.
When choosing the container
bear in mind that the volume of the milk
will increase by 2 or 3 times.
To obtain a creamier froth,
dip the cappuccino nozzle into the milk
and turn the container with slow movements
from the bottom upwards.
When the volume of the milk has doubled,
dip the cappuccino nozzle deep down
and continue to heat the milk.
Cappuccino

8
27
31 32 33
35
34
60s Max. STOP
STOP
2526
293028
OK!
5s
1
2
Discharge a small amount of steam Use one hand to hold the cappuccino tube
and the other to release the cappuccino maker
Remove the cappuccino nozzle Wash and clean using a pin Re-mount the cappuccino maker
Push the button and
turn the steam dial at the same time
Ready!
Wait until light comes on
Cleaning after making a Cappuccino
Hot Water