
10
4. Then select your required coee:
Recipe Quantity
Espresso (B7) ≃ 40 ml
Coee (B8)
≃ 180 ml
Long (B9)
≃ 160 ml
Coees selectable from (B10) and conrming
with (B4)
Ristretto ≃ 30 ml
Espresso lungo ≃ 120 ml
5. Preparation begins. The selected beverage appears on the
display, together with a progress bar which gradually lls
as preparation proceeds.
Please note:
At the end of delivery, to increase the quantity of coee in the
cup, just press "EXTRA" (B10) within 3 seconds. When the
required quantity is reached, stop with (B3).
Important! Making LONG coee :
Halfway through preparation, the machine requests a further
level measure of pre-ground coee. Proceed, then press
(B11).
Please note:
• If "Energy Saving" mode is active, you may have to wait a
few seconds before the rst coee is delivered.
• Various alarm messages could be displayed while using the
appliance (Fill tank, Empty grounds container, etc.). Their
meaning is explained in section "18. Troubleshooting".
• For hotter coee, see section "7.5 Tips for a hotter coee".
• If the coee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in section "18.
Troubleshooting".
7.4 Adjusting the coee mill
The coee mill is factory-set
in such a way that the coee
will be delivered correctly and
should not require regulating
initially.
However, if after making the
rst few coees you nd that
the coee is either too weak
and not creamy enough or de-
livery is too slow (a drop at a
time), this can be corrected by
adjusting the grinding adjust-
ment dial (A5) (g. 11).
11
Please note:
The grinding adjustment dial must only be turned when the
coee mill is in operation during the initial phase of coee
preparation.
If the coee is delivered too slowly or not
at all, turn one click clockwise towards 7.
For fuller bodied creamier coee, turn
one click anticlockwise towards 1 (do not
turn more than one click at a time other-
wise the coee could be delivered a drop
at a time).
The eect of the adjustment will be noticed only after making
at least a further 2 cups of coee. If this adjustment does not
produce the desired result, turn the dial another click.
7.5 Tips for a hotter coee
For hotter coee, proceed as follows:
• perform a rinse cycle by selecting the "Rinsing" function in
the settings menu (section "6.1 Rinsing");
• warm the cups with hot water using the hot water function
(see section "10. Delivering hot water");
• increase the coee temperature in the "Settings" menu
(see section "6.4 General"). Varying the temperature has
most eect for long beverages.
8. MAKING CAPPUCCINOS AND MILKBASED
COFFEES
Please note:
To avoid milk with poor froth or large bubbles, always clean the
milk container lid (D2) and hot water connection nozzle (A10)
as described in sections "8.4 Cleaning the milk containerafter
every use", "11.10 Cleaning the milk container" and "11.11
Cleaning the hot water nozzle".
8.1 Filling and attaching the milk container
1. Lift the milk container lid (D2) (g. 12);
1312
MILK
2. Fill the milk container (D5) with a sucient quantity of
milk, not exceeding the MAX level marked on the contain-
er (g. 13);