9
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the product is com-
plete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged.
Contact Customer Service (see enclosed guarantee leaet).
Installing the appliance
Important!
When you install the appliance, you should follow the follow-
ing safety warnings:
• The appliance gives o heat.
After positioning the appliance on the worktop, leave a
space of at least 3 cm between the surfaces of the appli-
ance and the side and rear walls and at least 15 cm above
the coee maker.
• Water penetrating the appliance could cause damage.
Do not place the appliance near taps or sinks.
• The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
• Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to the
value indicated on the rating plate on the bottom of the ap-
pliance.
Connect the appliance to an eciently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Using the coee maker for the rst time
Please note:
• Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill.The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the instructions in the section “Setting water
hardness”on page 15.
1. Plug the appliance into the mains socket .
2. Remove the water tank, ll to the MAX line with fresh
water then replace in the appliance (g. 1).
3. Turn the cappuccino maker outwards and place a contain-
er with a minimum capacity of 100 ml underneath (g.
2).
4. Place the main switch on the back of the appliance in the
Iposition (g. 3).
5. The lights , , ash.
6. Turn the steam dial anticlockwise as far as it will go (g.
5). This is priming the water system. (It is normal for the
machine to make some noise).
7. Wait for delivery of hot water to stop automatically. The
lights , , ash to indicate that you
must close the steam tap by turning the steam dial to the
0 position.
8. Turn the steam dial to the 0 position. The appliance goes
o automatically.
To use the appliance, turn it on.
Please note :
• When using the appliance for the rst time, you need to
make 4-5 cups of coee or 4-5 cappuccinos before the ap-
pliance starts to give satisfactory results.
TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the main switch on
the back of the appliance is in the Iposition (g. 3).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
• To turn the appliance on, press the button (g. 4).
The and lights ash while the appliance
is heating up and performing an automatic rinse cycle. By
circulating the hot water, the appliance heats both the
boiler and the internal circuits.
When the and lights remain on steadily, the
appliance is at temperature.
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.
