Delta HL6002 User manual

E
F
A
B
Assembly instructions HL6002/HL6500
Smartphone
Holder
x1 — Phone Holder
x1 — Bungee
x1 — Handlebar Clamp
x1 — 360° Mount
x2 — Rubber Shim
x1 — Thumb Screw
x1 — Short Bolt
x1 — Stem Mount
x6 — Foam Inserts
Parts
A
B
C
D
E
F
G
H
I
Tool Required
Phillips Head Screwdriver
WARNING
Using phone device while riding can cause accidents resulting in serious injury.
Important: Nuts and bolts can loosen over time, resulting in serious danger should the item fall off while in motion.
Check frequently to ensure all bolts are properly tightened. Ensure the device fits snugly in the holder before riding.
Not for off-road use.
STEM MOUNT OPTION
HANDLEBAR CLIP OPTION
H IG
Assembly video
Visit designbydelta.com/downloads
STEM BOLT
1
2
1
2
Using the Stem Mount
Remove existing stem cap from bicycle. Use existing stem bolt to install
Smartphone Holder stem mount (Part H) on to your bicycle stem.
NOTE: for landscape orientation install the stem mount as shown in
FIGURE 1
Connect phone holder to stem mount using short bolt (Part G) and
adjust angle before full tightening. If necessary use the adhesive foam
inserts (Part I) to provide a snug fit for your device. (FIGURE 2)
C
Open slightly in order to allow
easy access to insert the bolt.
Insert the bolt on the same side
as the locking mechanism
IMPORTANT SAFETY NOTE
Never loosen the stem clamp bolts.
D
FIGURE 2
FIGURE 1
(for landscape
orientation)

3
Using the Handlebar Clamp with 360° Rotation
How to use the 360° Rotation feature
IMPORTANT
SAFETY NOTE
Do not attach clamp
to any tapered section
of your handlebar.
1Connect 360° Mount (Part D) to rear of phone holder
using Short Bolt (Part G)
1To adjust the angle of the phone holder loosen
thumb screw. Pull the phone holder up slightly
so grooves are separated Rotate phone holder
into desired position. Once in place, tighten the
thumb screw.
2
Use thumb screw; tighten to secure the
handlebar clamp and mount.
If necessary use the adhesive foam inserts to
provide a snug fit for your device. (FIGURE 2)
Service: Please do not return to store;
for immediate response email
[e-mail]
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
Use rubber shims as needed (Part E) (FIGURE 1)
Place Handlebar Mount (Part C) in position
over the 360° Mount (Part D), be sure groves
are in lined up and in place. (FIGURE 2)
Open slightly in order to allow
easy access to insert the bolt.
Insert the bolt on the same side
as the locking mechanism
360°
FIGURE 1
FIGURE 2
FIGURE 2
011722