DENAGO CITY 1 User manual

[e-mail] or 1-877-755-2453(BIKE)
Rear Rack Assembly for CITY 1
Denago Rear Rack for the City 1.0-
The rack comes assembled along with
4bolts to secure your rack.
Please follow the below assembly instructions
Step 1- Unpack your rack and locate
the 4bolts.
Step 2-Place rack on rear wheel with
2 bars pointing towards the front of
the bike
Step 3- Loosen but do not completely remove the nuts and bolts on the top
of your rack. FOUR (4) positions. Once loosen you should be able to move the
bars freely. For the top-USE your DENAGO folding tool 5mm Allen wrench.
For under the rack, you will need a 10mm or adjustable wrench. In loosing
these 4 areas this will allow you to adjust the rack in STEP 5.
Step 4- Take one of the
black bolts and pass thru
the hole on the bottom of
the rear rack and align with
the treaded portion on the
bottom of the bike frame-
Tighten but keep slight
loose. Now do the same on
the other side. You will
need the 4mm Allen wrench

[e-mail] or 1-877-755-2453(BIKE)
Rear Rack Assembly for CITY 1
Step 5- You will need to
remove the 2 SILVER BOLTS
just below the seat clamp.
Once REMOVED TILT your
rack towards the front of
the bike and align the open
hole on the rack arms with
the threaded part on the
frame and secure the bolt.
Step 6-You can now slide and
adjust the RACK RODS to allow for
as much as possible FLAT/LEVEL
position on your rack. Once you
have established this tighten the
BOLTS on the TOP of the rear rack
first then confirm alignment and
position of bars and secure the
NUTS on the BOTTOM of the rack
Step7-Go OVER all areas on your
rack and TIGHTEN and SECURE all
BOLTS and NUTS.You should be
checking 6BOLTS and 2 NUTS.
If you have any questions or
concerns, we are here to help.
DO NOT TIGHTEN COMPLETELY YET. You need the movability.