Denon DVD-2930 Use and care manual

DVD-2930
BEFORE APPLYING THE UPDATE PLEASE
ENSURE YOU HAVE READ AND FULLY
UNDERSTAND THESE INSTRUCTIONS.
Reproduction, publication in electronic or any other form of
this software and this documentation without the express
written consent of the rightful owner is forbidden and will be
prosecuted by law.
© 2007 DENON UK
Warning:
Please read though these instructions completely before attempting to
update your player. The use of this update is completely at the owner’s
risk. DENON can not be held accountable for damage resulting to the
player or associated equipment as a result of improper use of this
update.
During the upgrade process it is imperative that you do not switch off
the unit's power and/or press any of the buttons on the unit or remote
control unless otherwise instructed.

NOTE:
When creating the update disc it must have a folder called
DVD_2930 within which should be the update file
D293SAVD.ROM.
If the update disc is not created or structured in this way the
player will not be able to read the update disc.
Upgrade-Procedure:
1. If you have not done so already, please connect the DVD-
2930 to a monitor using either the Composite or S-Video
connections (Page 9 of the user manual) then turn on the player
and monitor.
2. Please ensure that you do not have any discs currently inside
the player and the draw is closed. Initialize the player by holding
the SKIP FORWARD () and PLAY () buttons via the front
panel for longer than 3 seconds (until INITIALIZE is no longer
displayed on the monitor screen).
3. Open the draw of the DVD player, place the update disc onto
the tray and close the draw.
4. Please wait for approximately one minute for the update to
complete itself, after which the draw should open automatically.
On the monitor it should show the word LOADING followed by a
box showing FLASH-ERASE. Followed by FLASH-WRITE then
VERIFY.
Once the update is finished the word COMPLETE will appear on
the display. The draw of the player will open automatically.
5. Remove the disc from the tray then turn off the player by using
the (On/Off) button on the front panel.
6. Initialize the player by holding the SKIP FORWARD () and
PLAY () buttons via the front panel for longer than 3 seconds
(until INITIALIZE is no longer displayed on the monitor screen).

Notes:
Your player’s settings will have been returned to their factory defaults.
Please re-configure the player (User manual page 13) to your
requirements.
Denon do not advise the loading of any non-official firmware into your
DVD player.
Doing so could compromise the features and performance of your
player.
© 2007 DENON UK Moorbridge House, Padbury Oaks, 579
Bath Road, Longford, Middlesex, UB7 0EW.
All rights reserved.