Control Panel and Operations
Working Time Display: It counts down after work is started.
Heater Status: When illuminated, indicates heater is on.
Heater Button: Touching Heater key twice, flashes, indicating the heater is turned on.
To cancel heating, touch Heater key twice again, dims, indicating the heater is turned o.
Normal Cleaning Status: When illuminated as solid light, it indicates that normal
cleaning is underway. When illuminated as flashing light, it indicates that degas is
underway.
Degas: Degassing is recommended each time you add fresh solution to maximize
cleaning eciency. Touch the key twice to activate Degas. Cycle will run for 3 minutes.
The time display will count down to 00:00 at which point the degas process is complete.
Timer Quick Set Button. Touch the Time key, LED display shows the last timer setting.
Each touch increases the time by 5 minutes. The system has a memory and will retain the
timer setting for the next use.
Overheat protection warning light: If the unit is working improperly or has been running
for too long, the red warning light will illuminate, indicating the unit is under overheat
protection. The unit can not be operated until idling for 15 to 20 minutes. The warning light
then turns o and the operation can be resumed. You do not need to turn unit o.
Start/Stop Button: After powering on, the LED displays the last timer setting, and the
unit is ready under normal cleaning mode. Touch Start/Stop key twice and the cleaning
starts. The cleaning stops when the timer counts down to 00:00. If the unit needs to be
stopped before the timer runs out, touch Start/Stop key twice.
Multistage Thermometer: Solid green light indicates that the water temperature is
0-30% of the set temperature. Solid orange light indicates that the water temperature is
30-60% of the set temperature. Solid red light indicates that the water temperature is
60-90% of the set temperature. Flashing red light indicates that the water temperature
is close to the set temperature. All lights indicate that the water temperature is at the set
temperature (90-100%).
To prevent accidentally turning on or o the unit, the Start/Stop key needs to be
touched twice within 6 seconds to turn it on or o.
4
Indicator Lights
Functional Buttons
To prevent accidentally turning on or o the heater, the Heater key needs to be
touched twice within 6 seconds to turn it on or o. Heater Status light flashes, indicating
the heater is on. When the water reaches the set temperature, the heater will turn o
automatically.
IMPORTANT: Do not turn on the heater without water in the tank, as this will damage
the unit.
