Details Sonet User manual

Sonet Acoustic
Privacy System
X05372
Connect a cable to the left hand connector on each emitter.
Run the cables down behind the work surface and pull them to the
area where you plan to mount the controller.
Installation
Instructions
Place an emitter on either side of the wall in front of you
when sitting as you normally do when working. The emitters
should be at about ear height and 2 to 3 feet apart.
Emitter can either be placed facing inward for personal
acoustic privacy or outwards to mask the sounds created
by others.
Parts Check List:
• Emitter 2
• Controller 1
• Line Cord/Transformer 1
• Mounting Plates 3
• 12' Cable 2
• Wiring Clips 6
• Mounting Plate Pins 8
• Spare Velcro™ Pairs 2
®
1
2
®
For a better day at work.™
For a Hard Surface:
• Remove adhesive guards from
the Velcro pair on the back
of the emitter.
• Place the Emitter (with connectors down)
in the desired position on the wall and press.
For Fabric Covered Walls:
• Place a mounting plate with
rounded edge up on the spot
where you wish to hang the emitter.
• Push two mounting pins through
the slots in the mounting plate at
a steep angle so that the mounting
plate lays flat on the wall.
• Remove the Velcro adhesive guard
from the Emitter.
• Place the Emitter (with connectors down)
on the mounting plate and press.
Note:
Sonet is adjusted at the factory for optimum performance in an
open workspace, such as a cubicle. If the Sonet system is being
installed in a high ceiling office, a single adjustment is required
prior to mounting the controller.
With a paper clip, move switch 2from position Ato position B.

Arena Station / 25 Ottawa SW / Fourth Floor Grand Rapids, Michigan 49503 / www.details-worktools.com
©2001 Office Details, Inc., Grand Rapids, MI 49503. A Steelcase Company.
All rights reserved. Printed in U.S.A. 10/01
3 4
A Connect the cables from the emitters to a connector on the side
of the controller.
B Insert the plug from the Line Cord/Transformer into the receptacle on the side
of the controller. Plug the transformer into a standard 110v AC wall outlet.
A
B
Mount the controller so the volume control is easy to reach.
For a Hard Surface:
• Remove Velcro adhesive guard
from the back of the controller.
• Place the controller in the
desired position.
• Press to surface.
For Fabric Covered Walls:
• Follow step 1 for the mounting
plate installation.
• Remove Velcro adhesive guard
from the back of the controller.
• Place the controller on the
mounting plate and press.
5
Wait until you are comfortable with the emitter locations.
You may wish to reposition the emitters or the controller after initial installation.
Use the enclosed cable clips to fasten the wires to the wall and underside of the
worksurface. Allow clips to stay in position for about 8 hours before routing cables.
Alternative Wiring Scheme (Daisy Chaining):
Starting A with the left hand connector of the controller, run a cable
to the input connector on the first emitter. Then continue
B by connecting
the output connector to the input on the second emitter.
A
B
Important:
Sonet uses common telephone connectors and cables. Do not attach Sonet
components to telephone equipment, damage to the Sonet components
or to the telephone equipment may result.
Remember:
The volume setting should be gradually increased until you have achieved a
comfortable balance between the Sonet sound level and its masking effects.