DEVANTI HLH-E72-1500-AL User manual

ELECTRIC H E ATERMOUNTING AND OPERATING INSTRUCTIONSINTRODUCTIONThe patio heater is designed for indoor and outdoor use, to provide radiant heat which
warms people and objects rather than the air in between. It is mounted on an adjustable
bracket that allows the heat to be directed exactly where it is required. Its attractive,
lightweight design means that it is effective yet unobtrusive.
Pleasereadthefollowinginstructionscarefullybeforeuse. Thesafetyofthis heaterisguaranteedonlybyitscorrectusageinaccordancewiththes e instructions, thereforeitisrecommendedthattheyareretainedforfuture reference.
IMPORTANTSAFEGUARDS:
1. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
2. WARNING: In order to avoid overheating do not cover the heater.
WARNING: Do not cover.
3. Children of less than 3 years should be kept away unless continuously supervised.
4. Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children
aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
5. CAUTION — Some parts of this p roduct can become very hot and cause burns .Particular attention has to be given where children and vulnerable people are present.6. Do not use this h eater with a p rogrammer, timer, separate remote-control system or anyother device that switches t he heater on automatically, since a fire risk exists i f the heater is covered or pos itioned incorrectly.7. Do not use this h eater in the immediate surroundings of a bath, a shower or a swimming pool.8. WA R NING: This heater is not equipped with a d evice to control the room temperature. Do not use this heater in small rooms w hen they are occupied by persons not capable of leaving the room on their own, unles s cons tant supervision is p rovided.CAUTION·
voltage.
·Ensure that the heater has been securely fixed to the wall using the mounting
bracket .
·Disconnect from mains during installation, cleaning and / or lamp replacement and
ensure the lamp is cool.
·Do not handle the halogen lamp with bare hands If it is in advertently touched
remove finger marks with a soft cloth and methylated spirit or alcohol ,otherwise the
marks will burn into the quartz,causin premature heater failure.·Do not use an extension cable with this product.
·Keep the mains cable away from the body of the heater which will get hot during use.
·Do not cover or obstruct the heater when in use.
·Ensure that children do not tamper with the heater.
·Do not insert any object through any slot or opening in the heater.
·Warning - this appliance must be earthed.
Before us ing this appliance:
Check that the voltage indicated on the type plate corresponds to the mains supply
.,
INSTALLATION INSTRUCTIONS.The heater is fitted with a supply cable and moulded plug,therefore the terminals
should not be interfered with.The following points should be considered when positioning the heater:·Please observe the minimum safe distance between the heater body and any
inflammable surfaces.·Do not position the heater at an angle of more than 70° from the rear wall ( See fig.1 )
·If in any doubt,Please contact a suitably qualified electrician.·Keep out of the reach of children.Min. 20cm
Min. 50cm
Min. 2.4m
HLH-E72-1500-AL/HLH-E72-2000-AL/HLH-E73-3000-AL

1.Securely fasten the bracket to the mounting surface using the fixing in the bracket.2.Fix in the required angular postion by tightening the fixing bolt on the bracket at the rear of the heater.3.The bracket can be used to adjust the direction of the heater up and down (See Fig. 2 ).This is done by loosening the bolts fixing the heater to the bracket, and then retightening once the correct position is a chieved.Always isolate the heater from the mains supply when adjusting the angular position.·In the event of heater failure, or for spare parts or advice, please contact the manufacture in the first instance.·Disconnect from the mains before commencing any maintenance procedure including cleaning.·To ensure optimum heat effectiveness, it is recommended that after the heater has be enused for approximately 80-100 hours, that the guard and lamp are removed and there flector is wiped with a lint-free cloth before reassembling.·If the supply cord be comes damaged, it must be replaced by the manufacturer, its service agent or a similar qualified person.Caution: Do not handle lamp with bare hands. Remove finger marks with a sof tcloth and methylated spirits or alcohol. Finger marks will burn into quartz causing premature lamp failure. Correct Disposal of this productThis marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.Rio outer casing can reach high temperatures.Disposal of Waste Electrical and Electronic EquipmentThis symbol on the product or on its packaging indicates that this product should not be disposed of with your normal household waste. The separate collection and recycling of your waste electrical equipment at the time of its disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment.Specific Safety Instructions
WARNINGS
Do not use the heater in areas where
there is a risk of explosion or re from
ammable gases. Ensure that the heating area
is kept clear of combustible materials. Do not
use the heater in damp areas, without suitable
ventilation. This heater is not designed for use
within 1m or above a water source. Do not place
within one metre (1m) of any water source. Do
not place directly in front of, below or above any
power points or switches.
Fire risk exists if this heater is covered by
or positioned close to curtains or other
combustible materials.
• This heater is intended for domestic/
household use only.
• Always ensure that this heater is installed as per
the requirements noted in Australian Standard
AS/NZS 3000:2007.
• Always keep heater at least one metre (1m)
from combustible materials.
• DO NOT locate this heater directly below,
above or in front of the power supply socket
or switch.
• DO NOT use this heater within 1 metre
or above any water source.
• DO NOT use this heater in either the
bathroom or ensuite without suitable
ventilation.
• DO NOT use a 3rd party timer, or
programmable system with this heater.
• DO NOT clean the heater while the heater is
on or plugged into the mains power supply.
• DO NOT touch any part of the heater while
on, hot surfaces may burn.
• DO NOT use the wall heater as a dryer.
• DO NOT attempt to modify the heater,
power cord, power plug or the supplied
accessories in any way.
• DO NOT expose the heater to rain, water, or
use in damp wet conditions.
• NEVER cover this heater.
• NEVER carry the heater by its power supply cord.
• NEVER use with the power cord coiled,
bundled up or tied up. Always extend fully
before use.
• NEVER use the heater if any part of it is
damaged.
• Ensure that the heater is disconnected from
the mains supply when installing, cleaning
or removing/installing.
• Ensure this heater is not left on when
unattended.
• Ensure the heater is not used in areas
where ammable gases are present, e.g.
paint, petrol etc.
• Always turn the heater OFF at the power
point switch when not in use for extended
periods of time.
• Always allow the heater to cool, about one
(1) hour after the heater has been turned
off, before cleaning the heater.
• Always ensure that the power cord is fully
extended and NOT in contact with any part
of the heater.
• Always ensure that the heater is kept clean
and free from dust.
• Only use this heater when securely attached
to the wall.
• Do not look directly at the heater when
it is on.