Deye SUN-10K-SG04LP3-EU User manual

Inverter Operation Guide
Deye-SUN-10K-SG04LP3-EU
Editing Software ： WPS-11.1.0 Shanghai Energy Electronic Science and Technology Ltd.

01 Scenario
Connection
Configuration
Contents
02
03

Key elements
Battery：The Li-ion Battery Pack composed of 16 strings of cells
①
②
③
Simple home storage scenario PCS Control Panel
Scenario
1
②
③
①Invter : Deye-SUN-10K-SG04LP3-EU
Interconnection cable：Standard network cable
The LCD is touchscreen, below screen shows the
overall information of the inverter.

PIN1
RS485-B
PIN2
RS485-A
PIN3
GND
PIN4
CAN-H
PIN5
CAN-L
PIN6
GND
PIN7
RS485-A
PIN8
RS485-B
PCS Interfaces
Connection Between PCS and BMS
PCS Side BMS Side
PCS Interfaces and Connection
2
PIN1
RS485-B
PIN2
RS485-A
PIN3
--
PIN4
CAN-H
PIN5
CAN-L
PIN6
RS485-GND
PIN7
RS485-A
PIN8
RS485-B
1
Battery access terminals
2
Communication and
functional interface
3
PV\ACInput terminals
4
A:Inputminals
B:GEN PORT
A
B

Tap the touchscreen settings
button to enter the settings menu
This is the main menu for settings
• Check system connection
conforms
•Turn on the AC power switch
①
②
③
④
3.1 Matching Setting of Inverter and BMS-1
Click Basic Setting and check time Syncs、Beep、Auto D M.
(Click the touch screen to select the setting item, the physical
button Down and up can add or subtract the value, click the
touch screen check to confirm the saving of the setting
parameters.)
Set Batt mode to Lithium,battery capacity toXAh, maximum
charging current to X A, maximum discharge current to X A,
and check Activate Battery
√

Click the screen down button,
(1) column to set the charging SOC;
(2) To set the charging column, Grid Charg, Grid Signal must be checked;
(3) 24H means it won't be closed all the time. Gen Down Time: Indicates the
delay time that the generator stops working after it reaches the run time .
Lithium battery mode: Press the physical button to select the SHEnergy
protocol.
Shutdown threshold: If the SOC is lower than 10%, the inverter will
automatically shut down.
Low Batt: When the SOC is below 20%, the inverter alarms. Restart: Restore
the battery voltage at 40% AC output.
Click the screen down button
(1) default settings;
(2) Default settings;
(3) Shutdown 20%, low power 35, output recovery SOC: 50%.
⑤
⑥
⑦
3.1 Matching Setting of Inverter and BMS-2
√
√

Select Selling first
Follow the local grid code and select the appropriate grid
standard
⑧
⑨
3.1 Matching Setting of Inverter and BMS-3

Open the software and
click on the upper right
corner to add a power
station
Choose according to the
actual situation
Waiting for location
confirmation
Set the power station
name and installed
capacity
② ③ ④①
3.2 App Connection Settings-1

Add collector after
creation
Scan the SN code of
the corresponding
collector
ADD A 2.4GWIFI WiFi network test
⑤ ⑥ ⑦ ⑧
3.2 App Connection Settings-2

Connect to the collector WIFI Waiting for the configuration
to complete
Exit the configuration
interface when complete
⑨ ⑩ ⑪
3.2 App Connection Settings-3