APsmart RSD-S-PLC User manual

smart
RSD-S-PLC Quick Installation Guide
Step1. Buckle RSD-S-PLC onto the PV module frame.
A.Back buckle
B.Front buckle
Step 2. Connect the input connectors of the RSD-S-PLC to the junction box, the device
output DC voltage is within the range of 0.6 to 1v.
NOTE: Do not short-circuit the RSD-S-PLC output connectors, otherwise it will be damaged.
2021/08/06 Rev2.6 | Quick Installation Guide1
NOTE: When installing RSD-D cable, the bending radius of the cable near the casing must be greater than 50 mm.
Mounting brackets
INPUT- INPUT+
OUTPUT- OUTPUT+

smart
Step 3. CConnect the output connectors of the RSD-S-PLC in series to the string, the string
open-air DC voltage is within the range of (0.6 ~ 1v) X #RSD-S-PLCs. (This range may vary
due to different on-site environment.)
NOTE: Do not connect homerun to inverter before finishing all strings connections and tests.
√
×
×
2021/08/06 Rev2.6 | Quick Installation Guide2
Product information is subject to change without notice. (Please download manuals at www.APsmartglobal.com).
APsmart
600 Ericksen Ave NE, Suite 200 Seattle, WA 98110 | [phone]
[phone] | APsmartglobal.com | [e-mail]
Bending Radius of the cable >50mm
√