DHP Baby Knightly DA1503B4-E User manual

SKU Number
THIS INSTRUCTION BOOKLET
CONTAINS IMPORTANT SAFETY
UPC CODE:
INSTRUCTION MANUAL
Model No:
NOTE:
MONTANA 2.0 4 IN 1 CRIB
INFORMATION. PLEASE READ AND
KEEP FOR FUTURE REFERENCE.
_______ / _______ / _______
(TAKEN FROM CARTON)
_____________________________________
Date of purchase:
Lot number:
DO NOT RETURN PRODUCT TO THE STORE.
If a part is missing or damaged, contact our customer
service department. We will replace the part FREE of
charge
NEED HELP!
CALL US FOR ASSISTANCE
1-800-295-1980
DO NOT RETURN PRODUCT TO STORE
E-MAIL:[e-mail]
0-65857-17045-0 (Espresso)
0-65857-17048-1 (Driftwood)
(Espresso)
(Driftwood)
DA1503B4-G (Driftwood)
DA1503B4-E (Espresso)
39119020
39119044
Tel #: [phone]
E-Mail: [email protected]

*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*NEVER use bed with children under 15 months or over 50 lbs.
*ALWAYS follow assembly instructions.
*
*NEVER suspend strings over a bed.
*
*CAUTION
Infants can suffocate in gaps between crib sides and a mattress that is too small.
Follow warnings on all products in a crib.
INFANTS HAVE DIED IN TODDLER BEDS FROM ENTRAPMENT. Openings in and between bed parts can
entrap head and neck of a small child.
STRANGUALTION HAZARD. NEVER place bed near windows where cords from blinds or drapes may
strangle a child.
NEVER place items with a string, cord, or ribbon around a child's neck, such as hood strings or pacifier cords.
These items can catch on bed parts.
ENTRAPMENT HAZARD. To avoid dangerous gaps, any mattress used on this bed shall be a full-size crib
mattress at least 51-5/8 inches (1310 mm) in length, 27-1/4 inches (690 mm) in width, and a max thickness of
6 inches (150 mm).
To help prevent strangulation tighten all fasteners. A child can trap parts of the body or clothing on loose
fasteners.
If refinishing, use a non-toxic finish specified for children's products.
When child is able to pull to standing position, set mattress to lowest position and remove bumper pads, large
toys and other objects that could serve as steps for climbing out.
Never use plastic shipping bags or other plastic film as mattress covers because they can cause suffocation.
Replace teething rail if damaged or loose (if teething rail is provided for this model).
CAUTION: ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27-1/4 INCHES BY 51-5/8 INCHES
(69CM BY 131CM) WITH A THICKNESS NOT EXCEEDING 6 INCHES (15CM).
Check this product for damaged hardware, loose joints, loose bolts or other fasteners, missing parts or sharp
edges before assembly and frequently during use. Securely tighten loose bolts and other fasteners. DO NOT
use crib if any parts are missing, damaged or broken. Contact a customer service representative at 1-800-295-
1980 for replacement parts and instructional literature if needed. DO NOT substitute parts.
Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional padding under
an infant.
Stop using the crib when child begins to climb out or reaches the height of 35 inches (89 cm).
To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless
otherwise advised by your physician.
DO NOT place crib near window where cords from blinds or drapes may strangle a child.
Strings can cause strangulation! DO NOT place items with a string around a child's neck, such as hood strings
or pacifier cords. DO NOT suspend strings over a crib or attach strings to toys.
WARNING
Failure to follow these warnings and assembly instructions could result in serious injury or death.
Read all instructions before assembling crib. KEEP INSTRUCTIONS FOR FUTURE USE.
CUSTOMER SERVICE
If you are missing parts or have any questions about this product, contact our customer service representative first!
CALL 1-800-267-1739
You can also order parts by writing to the address listed below. Please include the product model number, color and
a detailed description of the part.
DHP Consumer Services
12345 Albert-Hudon Boulevard, Suite 100
Montreal, Quebec
Canada H1G 3L1
[email protected]

*
*
*
*
*
*
*
LIMITED WARRANTY
Dorel warrants its product to be free from defects in material and workmanship and
agrees to remedy any such defect. This warranty covers 1 year from the date of original
purchase. This warranty is valid only upon presentation of proof of purchase. This is solely
limited to the repair or replacement of defective furniture components and no assembly labor
is included. This warranty does not apply to any product which has been improperly
assembled, subjected to misuse or abuse or which has been altered or repaired in any way.
This warranty gives you specific legal rights and you may also have other rights which vary
from State to State.
WARNING: Should this product become damaged,
and/or components are broken or missing, DO NOT USE.
Assembly will require two people.
Estimated assembly time: 30 minutes.
CARE AND CLEANING
Dust regularly with a soft, lint-free cloth to prevent soil build-up. A damp cloth may be used
occasionally to clean surface. Dry immediately. Do not use any abrasives that may damage
finish. Excessive exposure to sunlight and extreme changes in temperature and moisture can
damage wood furniture.
MAINTENANCE
Check bolts/screws periodically and tighten them if necessary.
NOTES
Ensure all parts and components are present before beginning assembly.
Assemble on a soft, smooth surface to prevent damage to product finish.
Phillips head screw driver is not included.
DO NOT use power tools.
CAUTIONS: Adult assembly required.

HARDWARE LIST
1 2
3 4
5 6
7
Ø 1/4" X 15mm X 35mm Ø 1/4" X 15mm X 40mm
BOLT
6 PCS BOLT 8 PCS
Ø 1/4" X 15mm X 15mm
MATTRESS SUPPORT BOLT
16 PCS ALLEN KEY 1 PC
Ø 1/4" X 11 X 1.2mmT Ø 5/16" X 13 X 1.5mmT
SPRING WASHER
16 PCS SPRING WASHER 14 PCS
Ø 8mm X 30mm
WOOD DOWEL
2 PCS
MONTANA 2.0 4IN 1 CRIB
DA1503B4-E / DA1503B4-G

PARTS LIST
A B C
D E F
HEADBOARD
1 PC LEFT SIDE PANEL 1 PC RIGHT SIDE PANEL 1 PC
FRONT PANEL
1 PC BOTTOM RAIL 1 PC MATTRESS SUPPORT 1 PC
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

NOTE: When inserting bolts, turn clockwise until tight. Then loosen 1/2 -
3/4 of a turn. After crib is completely assembled, return to each bolt and
tighten. Use wax or soap on all bolts to facilitate assembly.
CRIB ASSEMBLY INSTRUCTION
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

STEP 1
Attach the left side panel (B) and right side panel (C) to the headboard (A) with bolts (1)
and spring washers (6). Use Allen Key (4) to tighten all bolts.
6
1
B
A
C
1
64
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

STEP 2
Attach mattress support (F) to headboard (A) and side panels (B & C) with mattress
support bolts (3) and spring washers (5).
Use Allen key (4) to tighten the bolts (3).
3
NOTE: The above photos and drawings showing how to properly attach the mattress
support are for reference only. Crib styles and colors will vary.
`5
AC
B5
3
4
F
CORRECT
"THIS SIDE UP"
label shows which
side to face
CORRECT
*Tabs on corners of
mattress support should
point up.
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

STEP 3
Attach front panel (D) to the left and right side panels (B) & (C) with bolts (2) and spring
washers (6) as shown.
Use Allen key (4) to tighten all bolts.
26
D
C
B
A
6
2
4
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

WARNINGS:
*ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27-1/4 INCHES BY
*The toddler bed or day bed is not intended for children under 15 months of age or over
50 lbs (22.7 kgs).
STEP 1: Detach the front panel (D) from the side panels (B & C) with Allen Key (4).
STEP 2: If mattress support (F) is not in the lowest position, unscrew bolts (1) from left & right
front posts (B & C) and move to the lowest position.
STEP 3: Attach bottom rail (E) to side panels (B & C) using wood dowels (7), bolts (1) and
spring washers (6). Use Allen Key (5) to tighten all bolts.
STEP 4: Ensure all bolts are tightly secured.
STEP 1: Follow steps 1 to 2 of the crib assembly instruction.
STEP 2: Follow steps 2 to 3 for the day bed assembly instruction located above (starting from crib).
51-5/8 INCHES (69CM BY 131CM) WITH A THICKNESS NOT EXCEEDING 6 INCHES
(15CM).
TODDLER BED & DAY BED ASSEMBLY: STARTING FROM SCRATCH
TODDLER BED & DAY BED ASSEMBLY: STARTING FROM CRIB
A
C
B
F
E
1
6
74
1
6
7
A
C
B
E
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

FULL SIZE BED ASSEMBLY INSTRUCTION
(HEADBOARD ONLY)
NOTE: FULL SIZE CONVERSION RAILS ARE NOT INCLUDED. DIAGRAMS ARE
FOR REFERENCE ONLY. BED RAILS MAY DIFFER FROM ILLUSTRATION.
IMPORTANT: STORE ALL EXTRA PARTS THAT YOU ARE NOT USING FOR POSSIBLE
FUTURE USE AS YOU MAY WISH TO CONVERT AGAIN. ALWAYS STORE THE ASSEMBLY
INSTRUCTIONS IN THE POUCH ATTACHED TO THE MATTRESS SUPPORT (F).
STEP 1
Attach a metal bedframe (not included) to the headboard (A) to convert your crib into
a full size bed using the headboard only.
A
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

FULL SIZE BED ASSEMBLY INSTRUCTION
(HEADBOARD AND FOOTBOARD)
NOTE: FULL SIZE CONVERSION RAILS ARE NOT INCLUDED. DIAGRAMS ARE
FOR REFERENCE ONLY. BED RAILS MAY DIFFER FROM ILLUSTRATION.
IMPORTANT: STORE ALL EXTRA PARTS THAT YOU ARE NOT USING FOR POSSIBLE
FUTURE USE AS YOU MAY WISH TO CONVERT AGAIN. ALWAYS STORE THE ASSEMBLY
INSTRUCTIONS IN THE POUCH ATTACHED TO THE MATTRESS SUPPORT (F).
STEP 1
Attach standard size metal bedrails (not included) to headboard (A) and front panel
(D) to convert your crib into a full size bed.
NOTE: Purchase the matching
Montana 2.0 Wooden Bedrails
for a coordinated look. See
next page for details!
A
D
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

Convert your crib into a toddler bed with the Montana 2.0 Toddler Bed
Conversion kit- model / SKU numbers DA1503-5-E / 39219022
(Espresso) or DA1503-5-G / 39219046 (Driftwood) sold separately.
Convert your crib into a full size platform bed with the Montana 2.0
Bedrails- model / SKU numbers DA1503-8-E /39319024 (Espresso) or
DA1503-8-G / 39319048 (Gray) sold separately.
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G

That's it ! You've finished assembling your 4in 1 convertible crib!
CAUTION: This unit is intended for use only with the
products and/or maximum weights indicated. Use with other
products and/or products heavier than the maximum weights
indicated may result in instability or cause possible injury.
Stop using crib when child begins
to climb out or reaches the height
of 35 inches (89 cm).
The TODDLER BED or DAY BED
is not intended for children under
15 months of age or over 50
pounds (22.7 kgs).
ANY MATTRESS USED IN THIS
CRIB MUST BE AT LEAST 27-1/4
INCHES BY 51-5/8 INCHES (69CM
BY 131CM) WITH A THICKNESS
NOT EXCEEDING 6 INCHES (15CM).
NEED HELP!
CALL US FOR ASSISTANCE
1-800-295-1980
DO NOT RETURN PRODUCT TO STORE
E-MAIL:[e-mail]
MONTANA 2.0 4 IN 1 CRIB
DA1503B4-E / DA1503B4-G
DO NOT RETURN PRODUCT TO THE RETAILERS.
If a part is missing or damaged, contact our customer
service department. We will replace the part FREE of
charge.
Tel #: [phone]
E-Mail: [email protected]

MODEL #: DA1503B4-E / DA1503B4-G
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE
PLEASE CONTACT CUSTOMER SERVICE REPRESENTATIVES AT THE FOLLOWING
NUMBERS SHOULD THERE BE ANY MISSING OR DEFECTIVE PART(S).
Request Date:
Name:
Shipping Address:
Street & Number:
City & State:
Zip Code:
Day Time Phone Number:
(including area code)
Date & Place of Purchase:
Part(s) description and quantity: (Please be sure to list model number or SKN number)
Customer Service Representative Mailing Address:
DHP Consumer Services, 12345 Albert-Hudon Boulevard, Suite 100, Montreal, QC, Canada, H1G 3L1
Customer Service
Email: [e-mail]
Customer Service Phone Number 1-800-267-1739