Diaz CM-03 User manual

Coulisse 12V Pull battery motor | CM-03 CM-05
V. 20-01
www.diaz.be 1
Introduction
Quick start guide
Manual
Coulisse 12V Pull battery motor
To activate the programming mode,
push 1x on the programming button.
Choose
channel
Channel
Programming button
Activate the motor
1
Activate the motor
by charging it
using a micro
USB cable.
P2
Indicator red:
Battery level = low
Indicator green:
Charging
Green light:
Charging complete
If your motor
does not respond
as described
in this manual,
please proceed to
troubleshooting
(pg 3).

Coulisse 12V Pull battery motor | CM-03 CM-05
V. 20-01
www.diaz.be 2
Programming mode
Alternative method (activate the motor)
+
+
Maintain P1 Pull the cord 2x Led = OK
Led = transportation mode
2 x
Connecting the rst remote control
2
STOP
P2
To activate the
programming
mode, push 1x on
the programming
button.
Programming mode
OK
Optional
Adjust upper and lower limit
1
or
or
Adjust
limit
Adjust
limit
+
3 sec
OK
OK
Upper limit
Lower limit
1.1
1.2
3 sec
+
STOP
STOP
Programming mode
Programming mode
To activate the
programming
mode, push 1x on
the programming
button.
Programming mode

Coulisse 12V Pull battery motor | CM-03 CM-05
V. 20-01
www.diaz.be 3
Go to favorite
position
3 sec
Favorite position
Set-up
2
2.1
2.2 Go to favorite position
2 sec
STOP
OK
Programming mode
Check rotational direction
Factory reset
20 sec
3
1
OK OK
OK
OR +
Troubleshooting
STOP
STOP
STOP
2 x
1 x
Connecting the rst remote control
2
OK
P2
Programming mode
Programming mode
Programming mode
If you opt to do a
factory reset of the
motor, you need
to follow all these
steps. Start and
end by pushing
the programming
button.
START RESET

Coulisse 12V Pull battery motor | CM-03 CM-05
V. 20-01
www.diaz.be 4
Set-up upper- and lower limit
4
Upper limit
Lower limit
4.1
4.2
+
+
2 sec
2 sec
or
or
Adjust
limit
Adjust
limit
OK
STOP
STOP
Warning: risk of
damage. Stop
the blind in time.
Programming mode
Programming mode
END RESET