Digiop NT1100 Chassis User manual

1
www.digiop.com
DO_NT1000_CoQ
7/9/2014
Congratulations on your new DIGIOP® Video and Data Management System
This guide provides setup instructions for your server hardware.
For more information, contact DIGIOP® Support at
877.972.2522 Toll Free • [e-mail] • www.digiop.com
DIGIOP® NT1100 Chassis
Hardware Quick Start Guide
Video and Data Management Systems

2
1. Getting Started
Unpacking the Contents
The following are included with your system. Please inspect these and the
other system components while unpacking.
• Quick Start Guide
• Surge Protection Notice
• Driver Disk
• USB Recovery Media
• External Power Supply
Choose a Proper Location
Select a location for the system that meets the following requirements.
Notice: Excessive heat can shorten the life of electronics.
• Adequate ventilation to avoid excessive heat (climate-controlled environment)
• Uninterrupted Power Supply (UPS)
• Moisture-free environment
• A place away from direct sunlight
• An area with minimal dust or debris
Site Installation
Hardware Setup – Connect all input devices and external peripherals to the system. Follow the order of connections displayed in Step 3.
• IP Camera(s)
• VGA Monitor
• Ethernet
• Mouse
• Keyboard
• Power Adapter
• PTZ Camera(s) - Optional
• Audio in (microphone) - Optional
• Powered Speakers - Optional
Notice: For proper indoor and outdoor cameras an in-line surge suppressor or equivalent should be used to reduce exposure to surges and lightning strikes.
2. About Your System
DriveBay
(NotUsed)
USB2.0Port
VerticalStand
PowerButton
PowerStatus
LED
HDDStatus
LED
4-in-1Card
Reader
Kensington
Lock
LANPort
VGAPort
Power
Connector
(DCIN)
Headphone/
LineOut
USB2.0
Ports(3)
USB3.0
Port
HDMI
Port
DisplayPort
Front Back
www.digiop.com

3
www.digiop.com
3. Setting Up Your System
1. Cable your monitor to the HDMI, VGA, or DisplayPort connector. 2. Connect your keyboard and mouse to USB 2.0 ports. You can use any of the available USB ports.
3. Connect the network cable. 4. Connect the power adapter to the DC IN connector, then plug it into a standard 120 VAC outlet.
5. Power on the computer and monitor.
Press

4
Notes
Copyright ©2014 innias. • Indianapolis, IN • tel: [phone] • fax: [phone] • support: 877.972.2522 • www.digiop.com
DIGIOP is a registered trademark of innias. All rights reserved.