Digital Watchdog DWC-HD321M4TIR User manual

12112013
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
HD-SDI Indoor Dome Camera
DWC-HD321M4TIR

2
PRECAUTIONS
Do not open or modify.
Do not open the case except during maintenence and installation,
for it may be dangerous and can cause damages
Do not put objects into the unit.
Keep metal objects and flammable substances from entering the camera.
It can cause fire, short-circuits, or other damages.
Be careful when handling the unit.
To prevent damage, do not drop the camera or subject it to shock or vibration.
Do not install near electric or magnetic fields.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of a kitchen or a boiler room,
as the temperature may rise to high levels.
Cleaning:
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface:
The material of the mounting surface must be strong enough to support the camera.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference, when the equipment is operated in a residential environment. This
equipment generates, uses, and radiates radio frequency energy; and if it is not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
WARNING: Changes or modifications are not expressly approved by the manufacturer.

Adjusting the Camera Gimbal 10
Troubleshooting
Warranty Information
Specifications
11
12-13
14
Table of Contents
3
TABLE OF CONTENTS
Introduction
Installation
Features
Parts and Descriptions
Dimensions
Inside the Box
Easy Installation
Connecting to Monitors
4
5
6
7
8
9

4
FEATURES*
1/2.8” CMOS Sensor
Highest Resolution 2.1 Megapixels (HD-SDI)
4.0mm Fixed Lens
12x Digital Zoom
50ft Range IR with Intelligent Camera Sync
TDN (True Day and Night/IR Cut Filter)
WDR (Wide Dynamic Range)
3D-DNR (3D Digital Noise Reduction)

PARTS & DESCRIPTION*
1Bottom Case
Camera Gimbal
Upper Case
Dome Cover
2
3
4
1
2
3
4
5

DIMENSIONS IN MILLIMETERS (IN)*
120.0 4.72”
9.0 0.3539.0 1.53”
89.4 3.52”
81.0 3.19”
89.0 3.50”
6

Included with your indoor dome camera
1
2
4
3
User Manual
Mounting Template
2 Machine Screws and 2 Dry Wall Anchors
Secondary Video-BNC Cable
7
INSIDE THE BOX*
12112013
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
HD-SDI Indoor Dome Camera
DWC-HD321M4TIR

EASY INSTALLATION*
1. To detach the camera’s cover dome from the camera’s module
press the small buttons located at the sides of the cover dome.
While pressing the buttons, disconnect the cover dome from the
camera’s base module.
2. Use the camera or mounting template to mark and drill the
necessary holes in the wall or ceiling.
3. Pull wires through and make connections.
4. Using the two (2) included screws, mount and secure the
camera to the wall or ceiling.
5. Adjust the camera’s Pan and Tilt. See page 10 for more
information.
6. Use the joystick to adjust the OSD menu. See pages
13-21 for more information.
7. Snap the camera’s cover dome to the camera base to complete
the installation.
8

Use the diagram below to connect to a Monitor or CRT Monitor properly.
Power Connection - 12VDC.
All cameras are equipped with a second video output for on-site configuration.
CONNECTING TO MONITORS*
9
12VDC
Monitor
High Definition Monitor
Second Video Output

ADJUSTING THE CAMERA GIMBAL*
1Rotation 360º 2Panning 360º
3Tilting 65º 3Tilting 55º IR LED
Non IRIR Non IR
Non IR
IR
IR
10