Digitus DN-70542 User manual

WIRELESS 300N USB 2.0
INTERNET ADAPTER
Quick Installation Guide
DN-70542 Rev.2 • DN-70543 Rev.2

2
Driver Installation
Please follow the below instructions to install the Wireless USB Adapter:
1. Insert the USB wireless network adapter into an available USB 2.0 port of
your computer. Please note that the USB connector side is directional, so
please flip the USB adapter when it cannot be inserted into the USB port.
2. The following message will appear on your computer, click ‘Cancel / Close’.
Under Windows XP
Under Windows Vista and Windows 7/8/10

3
3. Insert the driver CD into your CD-ROM. You can see autorun
screen below. If not, you can double click ‘autorun.exe’ on
CD.
Click ‘Install Driver’ to start the installation procedure.
4. Installation wizard will then be shown. Click ‘Next’ to continue.

4

5
5. Insert the USB wireless network adapter (DN-70542/DN-70543) into an USB
2.0 port of your computer, the system will find the new hardware and will
install the drivers automatically.
6. Once the installation is finished the computer will be asked to reboot. You
can click ‘Finish’ and reboot the computer to finish the driver installation.

6
7. After finishing driver installation, click adapter utility from your taskbar or
programs folder. Click “available networks”, select the wireless access point
you would like to connect and press “Add to Profile” button.
8. Fill in the security information if necessary, and then click “OK” to connect to
the wireless network.

7
9. Once connection is successful, it will show the status screen.
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the
requirements of Directive 1999/5/EC and the Directive 2011/65/EC for RoHS compliance. The
complete declaration of conformity can be requested by post under the below mentioned
manufacturer address.
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany