Directed XDR G6867T User manual

510-10644-01 (2020-10-27)© 2020 Directed, All rights reserved.
G6867T Digital (D2D) Control Center
(DS4 / DS4+)
Install Guide

2
Product Description
The G6867T control center is compatible with the following modules: DS4
and DS4+.
Control CenterLED Button
Mounting the Control Center
Note Once this replacement control center has been installed, all
remote controls must be paired with your system. See Remote Pair-
ing for details and follow the instructions for your remote control
type.
The control center’s position should be discussed with the vehicle owner prior
to installation since the antenna, with built-in status LED and Valet/Program,
must be visible/accessible to the customer.
The best position to locate the control center is centered high on the front
windshield. It can be mounted vertically or horizontally relative to the wind-
shield. Metallic window tint can also affect range negatively, so this should
be a consideration when determining the mounting location.
After you determine the best mounting location, follow these steps:
Clean the mounting area with a quality glass cleaner or alcohol to remove
any dirt or residue.
Plug the cable into the control center.
Mount the control center with double-sided tape.
Route the cable down the window pillar to the control module and plug the
cable in the control module.

3
CONTROL CENTER
CABLE
CONTROL
MODULE
Remote Pairing
Prepare the vehicle system to be Paired with a new remote
1. Open at least one vehicle door.
2. Turn the key to the ON position.
3. Within 5 seconds press and release the Control button on the Control
Center one time.
4. Within 5 seconds, press and hold the Control button on the Control
Center. The status LED begins flashing in single flash sequence and the
siren/horn sounds once to confirm the system is ready for remote pairing.
Release the button.
5. Locate your remote control model below and follow the instructions.
System Pairing will exit if:
• The ignition is turned off
• The open door is closed
• 60 seconds lapses with no actions
Note : Make sure the remote to be paired with the system is set for the desired
Car 1 or Car 2 operation.

4
LCD Remote Control :
1. Press and hold the
AUX
button for 8 seconds, the remote beeps once,
Main Menu is displayed.
Release the
AUX
button.
2. Press the AUX or
AUX
buttons until Pair is displayed.
3. Press and hold the
AUX
button until the remote beeps 3 times then release
the
AUX
button. The remote is now ready to pair with the system.
4. Press the
AUX
button.
5. Wait several seconds for feedback as the remote generates a security
encryption and sends it to the Control Center. If pairing is successful
the siren/horn sounds and the remote emits several tones. The screen
displays if the Pairing is successful or failed with corresponding text. If
pairing fails repeat step 4.
To exit pairing mode on the remote :
• Press and release the
A U
A U
X
X
button.
• Wait 30 seconds without pressing a command button on the remote.
Responder LED or Companion Remote Control :
1. Press and hold the
AUX
button for 8 seconds. The transmit LED will come
on solid. Release the
AUX
button.
2. Press and hold the
AUX
until the transmit LED flashes 3 times then comes
on solid.
3. Press the
AUX
button.
4. Wait several seconds for feedback as the remote generates a security
encryption and sends it to the Control Center. If pairing is successful the
siren/horn sounds and the 2-way remote emits several tones (the com-
panion remote does not generate tones). If pairing is not successful press
and release the
AUX
button once and then repeat steps 2 and 3.
To exit pairing mode on the remote :
• Press and release the
AUX
button once, then press and hold until the
transmit LED shuts off.
• Wait 30 seconds without pressing a command button on the remote
control.

5
GOVERNMENT REGULATIONS
This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference re-
ceived, including interference that may cause undesirable
operation.
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television, which
can be determined by turning the equipment OFF and ON, the user is encour-
aged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
To satisfy FCC RF exposure compliance requirements, the device and its an-
tenna must maintain a separation distance of 20 cm or more from the person’s
body, except for the hand and wrists, to satisfy RF exposure compliance.
WARNING! : Changes or modifications not expressly approved by
Directed Inc. could void user’s authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS-247 standards.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and

6
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence stan-
dards RSS-247. Son fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d’interférences et
(2) cet appareil doit accepter toute interférence, y compris celles pouvant
causer un mauvais fonctionnement de l’appareil.”
Health Canada RF Exposure Warning:
This device complies with Health Canada’s Safety Code. The installer of this
device should ensure that RF radiation is not emitted in excess of the Heath
Canada’s requirement. The device must maintain a separation distance of
20cm or more from the person’s body, except for the hands and wrists. Infor-
mation can be obtained at: http://www.hc-sc.gc.ca/ewh-semt/pubs/radia-
tion/radio_guide-lignes_direct/index-eng.php
Lignes Directrices de Santé Canada sur l’exposition aux radiofréquences:
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le pro-
gramme d’installation de cet appareil doit s’assurer que les rayonnements RF
n’est pas émis au-delà des limites établies par Santé Canada. L’emplacement
de l’appareil doit se situer à une distance de 20cm ou plus par rapport au
corps de la personne, à l’exception des mains et des poignets. Les informations
peuvent être obtenues à l’adresse Internet suivante: http://www.hc-sc.gc.ca/
ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-fra.php

7
LIMITED ONE YEAR CONSUMER WARRANTY
LIMITED ONE YEAR CONSUMER WARRANTY
For a period of ONE YEAR from the date of purchase of a Directed Electronics
remote start or security product, Directed Electronics. (“DIRECTED”) prom -ises
to the original purchaser, to repair or replace with a comparable reconditioned
piece, the security or remote start accessory piece (hereinafter the “Part”),
which proves to be defective in workmanship or material under normal use,
provided the following conditions are met: the Part was purchased from an
authorized DIRECTED dealer; and the Part is returned to DIRECTED, postage
prepaid, along with a clear, legible copy of the receipt or bill of sale bearing
the following information: consumer’s name, address, telephone number, the
authorized licensed dealer’s name and complete product and Part description.
This warranty is nontransferable and is automatically void if the Part has been
modified or used in a manner contrary to its intended purpose or the Part has
been damaged by accident, unreasonable use, neglect, improper service,
installation or other causes not arising out of defect in materials or construction.
TO THE MAXIMUM EXTENT ALLOWED BY LAW, EXCEPT AS STATED ABOVE,
ALL WARRANTIES, INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY,
IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR
PARTICULAR PURPOSE AND WARRANTY OF NONINFRINGEMENT OF
INTELLECTUAL PROPERTY, ARE EXPRESSLY EXCLUDED; AND DIRECTED
NEITHER ASSUMES NOR AUTHORIZES ANY PERSON OR ENTITY TO
ASSUME FOR IT ANY DUTY, OBLIGATION OR LIABILITY IN CONNECTION
WITH ITS PRODUCTS. DIRECTED HEREBY DISCLAIMS AND HAS ABSOLUTELY
NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING
DEALERS OR INSTALLERS. DIRECTED IS NOT OFFERING A GUARANTEE
OR INSURANCE AGAINST VANDALISM, DAMAGE, OR THEFT OF THE
AUTOMOBILE, ITS PARTS OR CONTENTS, AND DIRECTED HEREBY
DISCLAIMS ANY LIABILITY WHATSOEVER, INCLUDING WITHOUT
LIMITATION, LIABILITY FOR THEFT, DAMAGE, OR VANDALISM. IN THE
EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS
SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN
THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE
FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM
RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY

8
LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE PRICE OF
THE PART. DIRECTED SHALL NOT BE RESPONSIBLE FOR ANY DAMAGES
WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL
DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR THE LOSS OF TIME,
LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC
OPPORTUNITY AND THE LIKE. NOTWITHSTANDING THE ABOVE, THE
MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR
REPAIR AT DIRECTED’S OPTION THE PART AS DESCRIBED ABOVE.
This warranty only covers Parts sold within the United States of America and
Canada. Parts sold outside of the United States of America or Canada are
sold “AS-IS” and shall have NO WARRANTY, express or implied. Some states
do not allow limitations on how long an implied warranty will last or the
exclusion or limitation of incidental or consequential damages. This warranty
gives you specific legal rights and you may also have other rights that vary
from State to State. DIRECTED does not and has not authorized any person
or entity to create for it any other obligation, promise, duty or obligation in
connection with this Part. For further details relating to warranty information of
Directed products, please visit the support section of DIRECTED’s website at:
www.directed.com
920-10012-01 2013-07