Dirtydog 4x4 DD-N-JK2-07R User manual

Installation Instructions
Netting for JK 2 door 2007-up
DD-N-JK2-07R
J2NN07RC**
-Thank you for purchasing a Dirtydog 4x4 netting system.
Please read these instructions fully to familiarize yourself
with the installation. You should have 3 main pieces.
Right side, left side, and backside. Set aside 60 minutes
for the first time you install your netting. Installation is
done easiest with the hard top removed. The soft top
can be opened or closed.
Start with either side.
There is a buckle
attached to one corner.
This buckle goes to the
bottom back corner.
Attach the first strap at
the top behind the front
seat. See photo for
positioning.
Attach the strap at the
back next. Continue with
the balance of the straps
on both roll bars adjusting
the straps evenly . The
bottom one with the
buckle attaches later on to
the rear. Do the same for
the opposite side. 1

The next step is to install the
back side. Start at the back
and install the 8 buckles.
Once all 8 are snapped in
adjust the tension so the net
is centered and evenly
spaced.
The four straps at the top of
each side will connect to the
top piece after you have
installed the overhead piece.
Slide each half of the tailgate bar in the last row as shown
in the photo. This bar will connect at the center of the net
and then the whole bar is clipped into soft-top tailgate
clips. (Clips can be purchased form us or your local dealer.)
This last row is optional and can be cut off if not needed.
* unlimited model shown in photo

The final straps at the front
corners wraps over the
speaker bar. Wrap the long
strap around over the front
of the speaker/roll bar and
bring under and around up
the side and feed into the
ladderloc. There will be two
ladderlocs. The second
one is used for the side
strap.
1
2
3
Dirtydog 4x4
6-2045 Dundas Road
Mississauga, ON L4X 1M6
1-855-704-0708
Question? Call or email [email protected]
Adjust and tighten straps as needed to even out the net so it is
positioned properly. Your net comes with a one year warranty
against manufacturing defects. Cuts, abrasions, sun faded items
are not covered under the warranty.
3
Attach the balance of the straps along the top of the
roll bars. The two straps with loops on the side pieces get
connected with the straps on the overhead piece.

Contents
Buckles
4
Female
Buckles
Female
Buckles