Dirtydog 4x4 DD-P-JKFS-07 User manual

Installation Instructions
Front pet divider with rear seat saver
for Jeep Wrangler unlimited 2007-up
DD-P-JKFS-07
-Thank you for purchasing a Dirtydog 4x4 netting system.
Please read these instructions fully to familiarize yourself with
the installation. Set aside 20 minutes for the first time you
install your pet divider. Your pet divider/seat saver comes in
two main pieces. You start with the pet divider first.
In order to position the net properly. The dirtydog log faces
forward. There are 2 long straps at the top that wrap over the
roll bar and connect to the ladderloc sewn onto the net.Center
them and snug them up.
The two straps that run out
horizontilly at the top go over
top the roll bar and come out
around the side. These connect
into the cam buckles on the
net. (see Photo). Tighten up
both sides and postion the net
so everything is centered and
hanging evenly

The long straps at the bottom pull down and wrap underneath
the front seat seat brackets as shown. The straps come back up.
The next step is to attach it to
outside ladderloc hanging off
the bottom of the net. The
pet divider portion is now
installed.
Now to install the seat saver portion you need to insert the
aluminum pole in the pocket on one side of the fabric. After this is
done you will attach this to the pet divider using the nuts and bolts
provided.

Dirtydog 4x4
Mississauga, ON
Canada
1-855-704-0708
Question? Call or email [email protected]
Adjust and tighten straps as needed to even out the net so it is
positioned properly. Your pet divider comes with a three year warranty
against manufacturing defects. Cuts, abrasions, sun faded items are not
covered under the warranty.
The last step is to install the
final strap that reaches back to
the rear roll bar and connects
onto the ladderloc.
On the underside of the seat
protector you will find a short
piece of webbing attached.
with a snap. This piece wraps
around the loop at the back of
the seat as shown and snaps in
place.