Discount Car Stereo AUX-STS Instruction Manual

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
AUX-STS
QUICK START AUX INSTALLATION GUIDE FOR 2005-11 CADILLAC STS WITH XM TUNER MODULE

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•This document is provided as a GENERAL installation guide, some vehicles vary and may
require additional steps. We do not accept responsibility for third party labor charges or
modifications. Exercise due-diligence when installing this product.
•We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•Careless installation and operation can result in equipment damage.
Requirements
XM tuner module (with or without subscription)
Introduction
Many 2005-11 Cadillac STS includes an XM tuner module (metal box in remote
area/trunk) but no aux jack. Creating an aux port in these vehicles usually
requires disconnecting the XM Tuner; however, our AUX-STS cable requires
the XM Tuner module and retain XM subscription (if subscribed) to provide a
3.5mm ack to which users connect and play all kinds of audio devices including
MP3 players, Smartphones, Tablets, iPod etc. The AUX-STS also works if XM
subscription has expired. To verify vehicle has required XM tuner module, simply
press “BAND” button on radio until XM is displayed, if only AM/FM is displayed,
vehicle does not have required XM module and is not compatible with this part.
See Frequently Asked question at the end of this guide for more details.
Installation
Radio must be removed from dashboard to gain access to connectors.
1. Using a panel removal tool, unclip and remove entire panel surrounding
A/C vents (See Fig. 1)
Fig. 1
2. Remove 10mm screws securing radio to the dash (See Fig. 2)
Fig. 2
3. Pull radio forward to reveal connectors (See Fig. 3)

Fig. 3
radio connectors
4. Disconnect factory 16-pin XM radio plug (See Fig. 4) from radio (See
Fig. 3). To disconnect, pull back blue locking tab, then press and pull
black tab to release plug. (See Fig. 4)
Fig. 4
16-pin plug
Warning: GM radios have multiple 16-pin connectors “keyed” to avoid
connecting errors. The 16-pin plug included is “Keyed” to fit only the XM
connector on factory radio (See Fig.3)
When disconnecting factory plug, do not pull wires. Grasp plug to
remove.
5. Connect factory 16-pin plug to adapter harness 16-pin connector
(See Fig. 5)
Fig. 5
16-pin connector
6. Connect adapter 16-pin plug to radio cavity vacated in step 4
7. Carefully route audio jack (See Fig. 6) to a location on dash or nearby
panel where it will be mounted (within 4 ft). Final install location varies
by vehicle and customer’s preference.
Fig. 6
Audio jack
8. Optional: Drill a ¼” hole in dash or panel. Push jack threated shaft
through hole and secure with nut (See Fig. 7)

Fig.7
Warning: Jack may be left freestanding, but to be mounted, ensure
panel is no thicker than 1/8” otherwise shaft may not protrude enough
to engage with nut. If necessary, use dremel, sander etc. to thin panel,
Operation
1. Turn ignition and radio “ON”
2. Repeatedly press “BAND” button until XM is displayed
XM subscribers: Most recent XM or preview channel will play, otherwise
there may be silence.
3. Connect audio device to 3.5mm jack using the included 3 ft. audio cable or
similar (See Fig. 9).
Fig. 9
male to male cable
4. Search audio device for test track, press play.
5. Ensure audio device volume setting is 80% or more
6. Use radio volume control button to set playback level.
Warning: Playlist and Track selection is *NOT* possible from the radio.
You must use audio devices built-in controls to access music files.
7. To listen to XM (if subscribed), simply disconnect 3.5mm audio cable from
jack and operate XM as customary. Jack (see Fig. 6), must be empty.
8. If correct operation is confirmed go ahead and reinstall radio.

Frequently ask questions & troubleshooting
1. Dos the AUX-STS work in vehicles with Navigation?
YES; The AUX-STS also works in 2005-11 STS Navigation radios.
2. Does the AUX-STS work in Bose systems?
YES; works in Bose and Non-Bose applications
3. Will the AUX-STS work if XM subscription has expired?
YES; so long vehicle has an XM tuner module (DRR), the AUX-STS will work.
XM subscription not required; XM Tuner module (metal box hidden in
remote location) is required. To check for tuner, see question #4.
4. I’m not the original owner and don’t know if vehicle has required XM
Tuner. How can I find out without ripping car apart?
Turn radio “ON”, press “BAND” button to cycle through AM/FM/CD/XM. If
only AM/FM/CD is displayed, your vehicle does not have required XM Tuner
and not compatible with this part.
5. Can I install this cable without removing radio?
NO; The AUX-STS connects to the back of the radio.
6. My STS YQ4 Package has Advance DVD Navigation which includes A/V
Jacks on center console. Do I still need the AUX-STS
YES/NO;if equipped with A/V jacks, simply purchase an RCA to 3.5mm
adapter cable. If in need of an additional AUX input, purchase our AUX-STS
which provides an aux input via the XM port.
7. Will the “Not subscribed”(expired) version of this cable allow XM to
play when subscription is renewed?
NO; Not subscribed (expired) version of this cable will not allow XM playback
now or in the future. If you plan to renew subscription at later time,
purchase “subscribed” version.
Disclaimer
• This product has no affiliation with GM
• We’re not liable for misuse of this product.
•We recommend professional installation
Email [e-mail]
© 1995-Sep-21 Discount Car Stereo, Inc. All rights reserved. Information in this document is
subject to change without notice. Other products and companies referred to herein are
trademarks or registered trademarks of their respective companies or mark holders.