Discount Car Stereo BLU-CHRY User manual

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
BLU-CHRY
QUICK INSTALLATION GUIDE FOR 1995-02 CHRYLER RADIOS WITH CD CHANGER CONTROLS
created August 19, 2016
Revised: August 27, 2021

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•Careless installation and operation can result in equipment damage.
Requirements:
cd changer controlling radio
Introduction
Many older car owners looking for a simple way to play audio devices without
replacing the radio will be pleased to find this module. The BLU-CHRY adapter
provides a streaming solution for any Smartphone, Kindle, Tablet with A2DP
profile. A wireless connection means no wires, clutter or complicated setup.
The BLU-CHRY plug-n-play solution connects to factory radio 8-pin CD changer
port which guarantees to best possible sound and replaces the CD changer (if
present).
For this module to work, the 1995-02 square face radio pictures on page 1 with
the following buttons:
a."Disk ^" printed on preset # 1, and 8-pinCD changer port. (See Fig. 2)
b."Mode/Eject" button, 6 radio presets, Bass and Treble slider controls, "DIRECT
DISC SELECT 1-6" above radio presets. (See image on pg. 1)
c. European (Export) radio models:P04704345, P05269484, P04671088
See Frequently Asked question at the end of this guide for details.
Installation
Radio removal required to gain access to the connector. Vehicle specific radio
removal is not part of this guide but available upon request.
1. Connect adapter 8-pin plug (See Fig. 1) to 8-pin “CD” connector on
radio (See Fig. 2)
Fig. 1
8-pin plug
Fig. 2
Radio connector
2. Secure adapter box and proceed to next step.

Pairing
The pairing process varies between devices but the basic steps are the same.
This process is done upon initial install and will not have to be repeated
1. Turn Ignition and radio “ON”
LED inside adapter will flash (pairing mode)
2. On A2DP device: Go to Settings, Wireless & Networks, Bluetooth
Settings
3. Select Bluetooth and turn on.
4. Then select Bluetooth settings
5. Tap Scan for devices .
6. Wait for the Bluetooth device name to appear and select it. (See below)
LED inside adapter will glow steady
Operation
1. Turn ignition to “ACC” and radio “ON”
2. Press “MODE”button on radio to enter changer mode. Radio will
display Disc1 Track 1 as seen in Fig. 3
Fig. 3
3. Launch Smartphone or Tablet audio application and verify device
volume is set to at least 80%
4. Turn radio volume control button to set the playback level.
Warning: Playlist and track selection *NOT* possible from radio
buttons. Use smartphone built-in controls and display to access and
control audio files and applications
5. If correct operation is confirmed go ahead and reinstall radio.

Frequent ask questions & troubleshooting
1. Will the BLU-CHRY work on all Chrysler with 8-pin “CD connector?
NO;the BLU-CHRY works on 3 Chrysler CD changer controlling radios:
#1. Square face"5 preset radio with "Disk Up" on preset # 1, “Disc down”
on preset #5, 8-pin CD changer port. (See image on page 1)
#2."Square face"6 present radio with "Mode/Eject" button, Bass and
Treble slider controls, "DIRECT DISC SELECT 1-6" printed above radio
presets.
#3. European (Export) radio models:P04704345, P05269484,
P04671088—refer to white sticker on radio chassis.
2. My radio has a MODE button. Will the BLU-CHRY work?
Probable not. Radio has to have more than just a “MODE” button. Refer to
question 1 for additional button/label requirements to guarantee
compatibly.
3. Can I use the BLU-CHRY to make/receive phone calls?
NO;The BLU-CHRY supports Bluetooth music streaming (A2DP). Does not
support hands-free (HPF) profile.
4. Will I have to disconnect the CD changer?
YES, the BLU-CHRT uses the 8-pin CD changer port. Any and all factory
devices using this port will need to be disconnected. See our A2D-CHRY to
retain use of the CD changer.
5. Can I use radio buttons to control songs and text display?
NO, radio button does not control audio device. You must continue using
device built-in control and display just as you would in portable mode.
Disclaimer
• This product has no affiliation with Chrysler
• We’re not liable for misuse of this product.
•We recommend professional installation
Email [email protected]
© 1995-Aug-21 Discount Car Stereo, Inc. All rights reserved. Information in this document is
subject to change without notice. Other products and companies referred to herein are
trademarks or registered trademarks of their respective companies or mark holders.