Discount Car Stereo IL-CDR30 User manual

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
IL-CDR30
APPLE LIGHTNING ADAPTER INSTALLATION GUIDE FOR PORSCHE CDR30/31 RADIOS
Revised August 30, 2021

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
Careless installation and operation can result in equipment damage.
Requirement
cdr30 or cdr31 radios
Introduction
Portable audio products are everywhere, reflecting demand from active people
all over the world to take their music with them. Porsche offers an optional
3.5mm jack for the CDR30 and CDR 31 radios which may be satisfactory to
some, but those looking for a better solution we offer the iL-CDR30.
The iL-CDR30 users are able to play and charge any Apple Lightning device
including the iPhone XR, iPad Pro etc. without sacrificing the look and feel of the
dashboard components. The A2D-CDR30 replaces factory AUX jack (if so
equipped) and is also compatible with or without factory Hands-Free option.
See Frequently Asked question at the end of this guide for more details.
Installation
Radio removal required to gain access to connectors. For radio removal
instructions click here for radio removal instructions.
1. Disconnect Main Quadlock from radio (See Fig. 1) by squeezing
release tab at the top of the plug. Pull back on release tab to slide
plug from radio cavity.
Fig. 1
Radio plug
2. Connect installation Quadlock plug (See Fig. 4) to radio slot
3. Disconnect GREEN and BLUE 12-pin inserts (if present) from radio
plug (See Fig. 1)
Warning: Factory AUX (GREEN) insert is replaced by BLACK insert from
harness (See Fig. 3) GREEN insert remains disconnected.
If equipped with BOSE; transfer orange fiber leads (See Fig. 2) to harness
Quadlock vacant slot (See Fig.3)
Fig. 2
4. Connect factory BLUE insert (if present) to vacant slot on
harness Quadlock (To radio in Fig. 3)

Fig. 3
Note: factory GREEN plug remains disconnected (See Fig. 3)
5. Connect factory Quadlock plug (from step 1) to harness Quadlock connector
(To Car in Fig. 4)
Fig. 4
Quadlock plug/connector
6. Route Lightning plug (See Fig. 5) to desired mounting location on dashboard,
glove box, console etc. that is within 5 ft. of radio. Use caution to not cut,
pinch or crimp cable during this step and away from heat, humidity, moving
parts, or sharp metal objects. Damage to lightning plug may occur if
subject to abuse.
Fig. 5
Apple Lightning plug

Optional remote
Optional smart remote is not required for operation; however, instead juggling
smartphone while driving (which is outright dangerous), simply install in a more
convenient place on dashboard or steering wheel to operate your smartphone:
(Remote does not apply to the CDR30/31 radio functions)
1. Track up/down
2. Pause
3. Volume up/down
Pairing:
Operation:
Use wireless remote to perform the following functions on iOS7.0 and higher or
Android 4.4 and higher.
Contents:

Operation
1. Turn ignition and radio “ON”
2. Connect Apple device (iPod, iPad or iPhone) to Lightning plug
3. Apple device should show charging icon
4. Press CD/AUX button on radio repeatedly until “AUX Mode” is enabled.
Alternately: To switch from CD to AUX press the “AUX” Soft key)
5. From Apple device select a song of your choosing. Audio will be played
on car speakers.
6. Use radio volume knob to set playback level
Warning: Playlist and Track selection is *NOT* possible from the radio.
You must use the Apple device built-in controls to access music files.
User radio volume control button to set playback level.
7. If correct operation is confirmed, tuck away any extra wires and re-
install radio.
Frequent ask questions & troubleshooting
1. Why is your adapter different than what others are offering?
Our cable has a single 8-pin Lightning plug for both audio playback and
charging and will not damage your device. Other offerings have a lighting
plug (charging) and a 3.5mm (headphone plug) for audio playback.
2. My vehicle has optional AUX jack. Does the iL-CDR30 work in vehicles
with factory AUX?
YES; but factory AUX jack must be disconnected and will no longer function.
3. Does the iL-CDR30 work on all Porsche radios?
NO; the iL-CDR30 works on all Porsche Vehicles equipped with a CDR-30
and CDR-31 Radio. Not for vehicles equipped with PCM radios
4. Can I control Apple device from radio buttons?
NO; you must continue to use Apple built-in controls and display to
operate your device or optional remote control. CDR-30/31 volume
knob is used to set playback level.
5. My vehicle has factory Bluetooth hands-free. Will that still work after
installing your IL-CDR30?
YES; Factory Hand-free kit continues to work and not affected by this add-
on.
Disclaimer
• This product has no affiliation with Porsche or Apple
• There are no warranties expressed or implied by purchase of this product
• We’re not liable for misuse of this product.
•Aux mode must be enabled otherwise visit nearest Porsche dealer
• We recommend professional installation.
Email: [e-mail]
© 1995-21 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change
without notice. Other products and companies referred to herein are trademarks or registered trademarks
of their respective companies or mark holders.