Dish Network Over-the-Air Antenna User manual

Go to mydish.com/ota for details on setting up your OTA antenna
Got Questions?
OR
Give us a call at 1-800-333-DISH (3474)
CONNECT YOUR OTA ANTENNA TO YOUR TV
Turn your TV on, and take note of
the channel or input that it is on.
Connect your antenna to your TV’s
Antenna In/Air/Cable port.
• If your TV requires a conversion
box, connect your antenna to
the conversion box, and then
connect the box to the TV.
Using the buttons on your TV, or
your TV remote, press the Menu/
Settings,/Home button.
Select Channel/Setup/Auto Tuning/
Installation/System.
• If you are prompted to select Air
or Cable, select Air.
Select Scan Channels/Program
Channels/Autoscan/Autoprogram.
Select Start/Enter/OK to start scanning
and adding channels to your TV’s
channel lineup. Select OK/Done to
complete your scan.
CONNECT YOUR OTA ANTENNA TO YOUR RECEIVER
Attach the coax cable from your
OTA antenna to the coax port on
your OTA adapter.
Connect the USB end of your OTA
adapter to the USB port on your DISH
receiver.
Turn your television and receiver
on. Then, open the Menu for your
receiver.
Select “System Setup” on your screen,
and then select “Local Channels.”
Select “Scan Channels.”
• This scan could take up to
five minutes to complete.
When it is complete, you
will see a list of the OTA
channels that your antenna
found.
When the popup appears, select “OK”
and then select “Done.”

TM
Flip this sheet over for instructions on how to connect your Over-the-Air (OTA) Antenna
to your TV or receiver.