displayit flare User manual

Accessory Kiosk with Three Shelves
displayit.com 800.207.0311 After-Hours Emergency: Call or Text 678.723.5343
Updated 11/15/2019
Assembly Instructions Page 1
Parts List
Adjustable
Foot
ACCESSORY
KIOSK
SIDE
TOP
ACCESSORY
KIOSK
SIDE
BOTTOM
ACCESSORY
KIOSK
STANDARD
HORIZONTAL
Large Panel x2
Shelf Bracket
with Knob Lock x6
Top Plate x1
Shelf x3
Thumb Knob x4*
Side Top Vertical x2
*Extra parts are provided
Thumb Nut x4*
Side Bottom Vertical x2 Standard Horizontal
with Knob Locks x3
M8 Knob x18*
(Includes 6 pre-installed in horizontals
and 6 pre-installed in shelf brackets)
M8 Threaded
Socket
M8 Knob Lock
M8 x 24mm
Thread
1/4-20 x 1”Thread
1/4-20 Thread
.5” x .7” Oval Head
32” x 11” Shelf
Parts are not shown to scale
Back Edge
M8 Knob
Rubber Pads
Lock
Inline Splice x2
M8 Threaded
Sockets
Flare Frame Required
For Support

Accessory Kiosk with Three Shelves
displayit.com 800.207.0311 After-Hours Emergency: Call or Text 678.723.5343
Updated 11/15/2019
Assembly Instructions Page 2
4. Assemble the two sides to the
kiosk as seen above. The top and
bottoms attach together using an
inline splice and two M8 knobs.
6. Stand the kiosk up attach to the top
plate with two M8 knobs.
Note: The shelf (shown in green above)
makes a handy spacer between the
bottom of the kiosk and the Flare.
7. Adjust the bottom feet until the
Flare and kiosk are standing straight
(not leaning forwards or backwards). 8. Shelf brackets attach with thumb
knobs. Face the rubber pads upwards.
Set the shelf onto the brackets.
1. During Flare frame assembly, insert
two t-bolts into each channel of the top
horizontal. Continue building the Flare
frame per the Flare instructions. 3. Secure with four thumb nuts.
5A. Attach the horizontals to the left side as seen
above. The horizontals attach using knob locks
(See Knob Lock Instruction Details to the right.)
Note: The infill panels may be used as spacers.
5B. Slide the infill panels completely into the frame
and attach the right side.
5C. Attach the right side vertical to the horizontals. Ensure the “lock” teeth are
fully enaged and the
connection can’t wiggle.
ACCESSORY
KIOSK
SIDE
BOTTOM
ACCESSORY
KIOSK
SIDE
TOP
Inline
Splice
Adjustable
Foot
M8
Knobs
Threaded
Socket
Knobs Face
Backwards
Knob Lock Instruction Details
ACCESSORY
KIOSK
STANDARD
HORIZONTAL
ACCESSORY
KIOSK
STANDARD
HORIZONTAL
ACCESSORY
KIOSK
STANDARD
HORIZONTAL
B Tighten knob clockwise
A. Insert lock into channel
Shelf used
as spacer
2. Place the kiosk top plate on top of
the flare with the four t-bolts passing
through the four holes