Displays2go ENCLTV5055 User manual

User ManualUser Manual
SKUs: ENCLTV5055, ENCLTV5765SKUs: ENCLTV5055, ENCLTV5765
OUTDOOR PROTECTIVEOUTDOOR PROTECTIVE
ENCLOSUREENCLOSURE

2
PARTS LIST
PART QUANTITY
A: Enclosure* ....................................................................................................... 1
B: Tempered Glass* ............................................................................................ 1
C: Hydraulic Rod*............................................................................................... 2
D: Fan* ................................................................................................................. 2
E: Thermostat*...................................................................................................... 1
F: Tilt Bracket*....................1
G: Hardware (at right) ......1
H: Key .................................2
I: Rubber Gaskets...............2
J: Rod*................................2
*: Arrives assembled
NOTE: 2-3 person assembly
Tools Required: Drill; Phillips
Head Screwdriver
If you have any questions regarding our products, please visit us at www.displays2go.com or
contact Displays2go customer service at 844-221-3388.
Scan QR code
to visit product
page

3
NOTE: Additional hard wire installation
may be required by a licensed
electrician. User may choose to utilize
an outdoor rated power strip.
1. Remove one of the bottom covers to pass
cables for TV and fan through. Insert rubber
gasket into hole.
NOTE: Wires for fan come attached to fan.
2. Remove bracket from the TV enclosure by
unscrewing pre-attached bolts.
ATTACH BRACKET TO TV
3. Mount the the bracket arms to the
back of the TV, using the M4/M6
screws.
4. Mount bracket to the arms by
tightening all screws to attach.
5. To hold unit door up, insert
metal rod into hole. This is located
along the hydraulic rods.
MOUNT ENCLOSURE TO WALL
6. Drill four 8mm holes into desired
wall, being careful to measure for
appropriate dimensions and level
installation.
7. Put expansion screw caps into
the holes.
8. Two people should hold the unit against
the wall, while a third inserts and tightens
expansion screws.
NOTE: Enclosure door may need to be held
open while installing.

4
Eny rEny r
w prtivw prtiv
eosur!eosur!
CONTACT INFORMATION:
www.displays2go.com
PHONE: [phone]
MOUNT TV TO ENCLOSURE
9. Two people lift the TV and carefully insert into the enclosure.
10. Fit bracket arms attached to the back of the TV onto the mounting bracket, which comes
pre-installed inside the enclosure.
11. Reach under TV to tighten screw on bottom of the bracket, which will hold unit in place.
12. Slide cable through hole at the bottom of the enclosure.
INSTALLATION NOTES
TROUBLESHOOTING
If unit’s fans do not work, check for the following:
- No Power | Solution: Connect to power supply
- Temperature Too Hot/Cold | Solution: Set thermostat to proper temperature (~77 °F)
ENVIRONMENT
- Wall should be flat and able to bear the weight of the unit.
- Keep away from heat sources and direct sunlight.
- Fans on unit can be turned on to help circulate air. Power switch is on inside top of unit.
SPECIFICATIONS
Voltage 110/220 V
Rated Power 60W
Working Temperature 14 - 122F
Product Weight ENCLTV5055: 88.2 lbs
ENCLTV5765: 124.8 lbs
Dimensions ENCLTV5055: 53.9” (L) x 32” (W) x 6.9” (D)
ENCLTV5765: 72.3” (L) x 42.1” (W) x 6.9” (D)
Power Cords (Fan) UL Listed