DIW Funk DHS-12 User manual

important safety instructionsto radio devices
1. General information
Electrical devices, packaging material, batteries, etc. are not toys and do not belong within the reach
of children. Packaging and wearing materials must be disposed of in an environmentally friendly
manner.
2.Important safety instructions:
Read the operating instructions carefully and keep them. Only pass the product on to other people
together with the operating instructions.
If you do not observe the safety instructions and information in these operating instructions, we are
not liable for any injuries or property damage that may result. In addition, the warranty guarantee
expires in such cases.
The product is not a toy. Keep the device, accessories and packaging away from children.
Handle the product with care. It can be damaged by bumps, hits or falling from a small height.
Download the current operating instructions from www.diw-gmbh.de diw-punkt DP_download.html
Contact with moisture must be avoided at all costs. Protect the product from extreme
temperatures, direct sunlight, strong shocks, high humidity, moisture, vapors and solvents.
For safety and regulatory reasons, you may not convert and or modify the product. If you use the
product for purposes other than those described above, the product may be damaged. In addition,
improper use can cause hazards such as short circuits, fire, etc.
If safe operation is no longer possible, take the product out of service and protect it from
unintentional use. Safe operation can no longer be guaranteed if the product shows visible
damage, no longer works properly, has been exposed to unfavorable environmental conditions or
has been subjected to transport loads.
Do not use this product in hospitals or medical facilities. Although the transmitter of the radio
remote control only emits relatively weak radio signals, these can also lead to malfunctions in life-
support systems. The same may apply in other areas. The maximum transmission power is <10
dBm
Handling batteries:
Remove the battery if you don't use the device for a long time to avoid damage caused by
leakage. They can cause acid burns on skin contact.
Do not leave batteries lying around, they could be swallowed by children or pets.
Do not ingest the battery!Risk of burns from hazardous substances. A product may
contain a button cell or battery. If a button cell battery is swallowed, severe internal burns can
occur in as little as 2 hours and can result in death.
=> Keep new and used batteries away from children! If you think batteries have been swallowed or
are in any part of the body, seek medical help immediately.
If the battery compartment does not close securely, stop using the product and keep it away from
children and pets.
Do not disassemble, short-circuit, or throw batteries into fire. Never attempt to charge non-
rechargeable batteries. There is a risk of explosion
Die allgThe rules of electrical engineering must be observed in any case.
. Battery law, dangers & safety, information on environmental protection
At the end of its useful life, this product must not be disposed of with normal household waste, but
must be taken to a collection point for the recycling of electrical and electronic equipment. This is
indicated by the crossed-out wheeled bin symbol on the product, instructions for use or packaging.
Batteriegesetz: Some devices come with batteries that are used to operate the devices. These can
be permanently installed in the devices. We are obliged to inform our customers of the battery
ordinance in connection with the sale of batteries:
Please dispose of all batteries as required by law, disposal in household waste is expressly
prohibited. You can hand in the batteries and rechargeable batteries at municipal collection points or
in local shops free of charge. Batteries purchased from us can also be returned to the following
address after use with proof of purchase. Please post sufficiently: DIW-GmbH, Balanstr. 89 b, 81539
Munich. We replace the letter postage. Batteries that contain harmful substances are marked with the
symbol of a crossed-out garbage can, the symbols are the chemical names of the harmful
substances contained. "CD" stands for cadmium, "Pb" for lead, "Hg" for mercury, "Li" for lithium, "Ni"
for nickel, "Mh" for metal hydride and "Zi" for zinc. The materials are recyclable according to their
labeling. By reusing, material recycling or other forms of recycling old devices, you are making an
important contribution to protecting our environment. Please ask the municipal administration for the
responsible disposal point.
4. Guarantee, guarantee:Legal regulations apply. There is no warranty claim for damage caused by
non-observance of the operating instructions (short form and online instructions). Liability or further
claims, in particular claims for compensation for personal injury or damage to property caused by
non-functioning or faulty functions, are excluded.
Current and detailed information on the Internet:
►► https://www.diw-gmbh.de/FAQ_index.html ◄◄
DIW-GmbH hereby declares that the„DIW-Funk“ radios DHS-12 and DKS-10 (RSL8 3T | RSL884T)
are in accordance with the basic requirements and the other relevant provisions of Directive
2014/53/EU.
Declarations of Conformity online at:https://www.diw-gmbh.de/DIW-Punkt/DP_Download.html
Errors, design changes and technical data are subject to change without prior notice in the interests
of constant product improvement (06-2022). Made in China.
Importer:
DIW Dipl.-Ing. Weber office equipment GmbH,
Balanstrasse 89b, DE-81539 Munich.
WEEE-Reg.-Nr.: DE47592106 | LUCID-Reg-Nr.: DE4746603811223
Description of the devices, compatibility lists, FAQs and certificates can be found on
the manufacturer's website
► https://www.diw-gmbh.de/DIW-Funk ◄

operation manualHand- + Key-Sender
Hand-Sender: DHS-12 (RSL863T) |Key-Sender: DKS-10(RSL884T)
Intended Use:The hand-held transmitters DHS-12 and DKS-10 are radio transmitters and can
wirelessly switch suitable radio receivers on and off or dim them.The configuration and the dimming
function depends on your radio receiver. Detailed information can be found in its user manual.
The remote control can control an unlimited number of compatible wireless sockets.
Radio remote control:DHS-12 Key-Sender DKS-10
controls
DHS-12 DKS-10
1. LED 1. LED
2. Control buttons (ON) 2. A
3. ALL ON ALL OFF button 3. OFF
4. Code setting knob 4th chain
5. Battery compartment cover 5.Battery
compartment
Installing/replacing the battery
1. Remove the battery compartment cover (5) on the back of the remote control.
2. Insert a round cell battery, type CR2032, into the battery compartment. The positive pole must
point upwards (see "+" printed on the battery). Push the battery all the way into the battery
compartment.
3. Close the battery compartment. The battery must be replaced if the range of the remote control
decreases noticeably or if the indicator lamp (1) no longer lights up when you press a button.
Key Functions DHS-12; The key function DKS-10;
- Control buttons (2) left = ON right = OFF. Top (1) = ON, bottom (2) = OFF
- upper 3 rows: switching of channels 1, 2 and 3
- 4th row (3) ALL ON and ALL OFF turns channels 1 to 3 on and off simultaneously.
- Slide switch (4), assigns channels 4~6,7~9,10~12 to the top 3 row buttons
The indicator lamp (1) lights up each time a button is pressed.
Dimming function of the radio hand-held transmitter – only with a suitable dimmer receiver:
- Press the "ON" button to switch on the light in the last saved brightness.
- Press the "ON" button again, the light gets darker and brighter again until
press "ON" again. This new brightness is then stored.
- If you press "OFF", the light goes out, but the last brightness level remains saved.
- to switch off, press the “OFF” button.
The configuration depends on the radio receiver you are using. Detailed information can be found in
its user manual.
The remote control can control an unlimited number of compatible wireless receivers.
=> this is how you pair a radio receiver with the hand-held transmitter:
1.) Normally turn on the receiver or press and hold the receiver's learning button for 3 seconds to put
the receiver into learning status (LED flashes)
2.) then press and hold the transmitter "ON" button for 3 seconds until the LED stops flashing and
stays on. Some receivers confirm the teach-in with a short switch.
If you want to train additional receivers, start again at point 1.
Erasing the code
The transmitter does not store the code, but it can help clear the receiver's code.
To put a receiver into learning status, turn it on or press and hold the receiver's learning button for 3
seconds (LED flashes).
During learning mode, press and hold the transmitter "OFF" button for 3 seconds until the receiver's
LED stops flashing and stays on, the code has been cleared successfully. Some receivers confirm
the deletion with a short switch.
Since there are different receivers, it is always better to use the operating
instructions for the respective receiver for pairing and deleting.
Operation
Technical Data DHS-12 (DKS-10)
Battery type .…..…: CR2032 (included)
Channels........…....: 12 Channels+ All on All off Channel | DKS-10: 1
channel
Transmission frequency ..: 433.92 MHz
Range ......: typically 30 m (outdoors)
Transmission power …: <10 dBm
Dimensions DHS-12 (WxHxD):110 x 38 x 13 mm
Dimensions DKS-10 (WxHxD): 45 x 30 x 13.5 mm
Suitable for all recipients
and compatible brands.
DIW radio series:
Radio plug:
DSR-2300 (item no.: 423 023) radio-controlled socket 2300W
DWR-2000 (Art. No.: 423 006) radio + WiFi socket 2000W
DGR-2000 (Art. No.: 423 070) Gateway + radio + WiFi socket 2000W
Wireless built-in switch & dimmer:
DES-2300 .….: (Art.-No.: 423 019) wireless built-in switch 230V 2300W
DES-2300S ...: (Art.-No.: 423 021) Wireless built-in switch with switch connection
DED-100 ....…: (Art.-No.: 423 009) radio built-in dimmer also for LED 150W
Mini power switching module 500W:
DPM-3500 ….: (Art.-No.: 423 008) wireless built-in switch 230V 2300W
Touch wireless light switch & roller blind switch:
Light - DTWS-10 ….: (Item no.: 423 014) Glass touch light switch
Roller blind DTRS-500...: (Article no.: 423 015) Glass touch blind switch
© DIW Dipl.-Ing. Weber Office Equipment Ltd. All rights reserved. Reproduction, even in part, is prohibited.
Reproductions of any kind require the written permission of the publisher.