Dorel Home Products WM6094 User manual

Weight Limit: 250 lb / 113 kg
C.W.-2022.5.31 B34WM609400-010045
Thank you for purchasing from Dorel!
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY
Double Rocker Chair
WM6094 (Taupe Microfiber)
WM6094-DO (Beige Microfiber)
WM6094GN (Green Velvet)
Date of Purchase Lot Number (TAKEN FROM CARTON)
2021 Dorel Home Products All Rights Reserved
C
DO NOT RETURN TO THE STORE !
If parts are missing or damaged,we will gladly ship your
replacement parts free of charge.
Visit www.dhpfurniture.com/eng/replacement-
parts or call Toll-Free 1-800-267-1739
You can also chat with us at www.dhpfurniture.com

Limited 1 year Warranty
Dorel warrants this product to be free from defects in material and
workmanship and agrees to remedy any such defect. This warranty covers
one year from the date of original purchase from authorized retailers. This is
solely limited to the repair or replacement of defective parts and assembly labor
is not included.
This warranty does not apply to any product which has been improperly
assembled, subjected to misuse or abuse or which has been altered or repaired
in any
way.The warranty does not cover wearing, tearing, fading or splitting of the fabric
(where applicable). Liability for consequential damages is excluded to the extent
exclusion is permitted by law. This warranty gives you specific legal rights and
you may also have other rights which vary from state to state or province to
province.
To obtain warranty service, purchaser must present original bill of sale.
Components repaired or replaced are warranted through the remainder of the
original warranty period only. The defective components will be repaired or
replaced without charge, subject to the terms and conditions described above.
Visit www.dhpfurniture.com to view the limited warranty valid in the U.S.
and Canada. This product is
packaged in 1 carton
30 mins
Do NOT use
powertools
Read Before Beginning Assembly
●
Work in a spacious area and near where the unit will be used, preferably on a
carpet, or use a piece of the cardboard packaging to protect your floor and
product.
Make sure all parts are included. Most parts are labeled or stamped on the raw
edge.
Read each step carefully. It is very important that each step of the instructions is
p erformed in the correct order. If these steps are not followed in s equence,
assembly difficulties will occure.
This product may contain small components. Please ensure that they are kept
away from small children.
This product is designed for home use and not intended for commercial use.
●
●
●
●
Contact Us!
For help with assembly, identifying parts, product information or to order
parts, please contact us:
DHP Consumer Services
12345 Albert Hudon, Suite 100,
Montreal, Quebec H1G 3L1
[email protected]
1-800-267-1739
Monday to Friday
Saturday
Sunday
9 am to 9 pm (Eastern Time) 10
am to 6:30 pm (Eastern Time) 11
am to 7 pm (Eastern Time)
Chat
with us! www.dhpfurniture.com

PART NUMBERS
PART
LABELS WM6094
(Taupe Microfiber)
A
B
Each part has a unique part number.
Please reference the appropriate part
number when contacting customer
service for replacement parts.
Before throwing any packaging, please
verify all contents and make sure you
have received all the parts listed
above!
C
D
E
3
PARTS LIST
ABC D
CHAIR BACK
X1PC
SEAT BASE
X1PC
RIGHT ARM
X1PCS
E
LEFT ARM
X1PCS
LEG
X2PCS
WM6094-DO
(Beige Microfiber)
T806820
T806830
T806840
T806850
T806860
T806870
T806880
T806890
T806900
T806860
WM6094GN
(Green Velvet)
T806860
T808850
T808860
T808870
T808880

4
Please do not completely tighten all the hardware, until the entire
assembly is complete, unless otherwise indicated in the step-by-
step instructions.
The screw(s), bolt(s) to be used at each step are shown in actual
size in the lower right corner of the page.
Hardware Pack
WM6094(Taupe)
WM6094-DO(Beige)
WM6094GN (Green)
HP #:TWM6094-01
HARDWA
RE LIST
1
12 2
ALLEN KEY
1 PC
BOLT
Ø5/16" *2 3/4"
14 PCS
3
BOLT
Ø5/16" *3 1/2"
4 PCS
FLAT WASHER
Ø22mmX1.8mm
14 PCS
FLAT WASHER
Ø16mm X 1.0mm
4 PCS
45
SPRING WASHER
Ø12.5mm X 2mm
18 PCS
6

5
Step 1
3
1
6
4
6
4
X4
1
1
X4 X4
B
A
Place chair back (B) on a clean, smooth
surface.
Pull back the fabric lining on seat base (A).
Attach seat base (A) to chair back (B) with flat
washers ❹, spring washers ❻ and hex socket
head bolts ❶. Use Allen key ❸ to tighten the
bolts.
Turn the assembled unit upright.
NOTE: Do not fully tighten the bolts. Leaving
the bolts loose will facilitate assembly in the
following steps.

6
Step 2
B
A
C
D
Attach left arm (C) to chair back (B) by
inserting the metal bracket on left arm (C)
into the metal glide on chair back (B). Push
the left arm (C) with a downward force to
secure it into place.
Repeat this step to attach right arm (D) to
chair back (B).

Step 3
7
3
1
6
4
6
4
X8
1
1
X8 X8
A
C
D
With the help of another person, gently place
the unit on chair back (B) and pull back the
fabric lining underneath seat base(A).
Secure left arm (C) and right arm (D) to seat
base (A) with flat washers ❹, spring washers
❻and hex socket head bolts ❶. Use Allen
key ❸ to tighten the bolts.
Place the fabric lining back into place.
NOTE: Do not fully tighten the bolts. Leaving
the bolts loose will facilitate assembly in the
following steps.

Step 4
8
315
4
6
4
X2
1
1
X2 X2
A
CD
A
CD
B
B
Pull back the lower fabric lining underneath
chair back (B).
Secure left arm (C) and right arm (D) to chair
back (B) with flat washers ❹, spring washers
❻and hex socket head bolts ❶. Use Allen
key ❸ to tighten the bolts.
Place the fabric lining back into place.
Note: Tighten all bolts previously installed.

Step 5
9
3
2
5
4
6
X4
5
X4 X4
2
2
A
E
E
With the help of another person, gently
turn the unit upside down.
Attach legs (E) to arms (C & D) with flat
washers ❺, spring washers ❻ and hex
socket head bolts ❷. Use Allen key ❸
to tighten the bolts.
Turn the rocker upright.

10
CAUTION: This unit is intended for use only with the products and/or
maximum weights indicated. Use with other products and/or products heavier
than the maximum weights indicated may result in instability or cause
possible injury.
Helpful Hints
That's it ! You've finished assembling your rocker chair!
Weight Limit:
250 lb / 113 kg
● Move your new furniture carefully, with two people
lifting and carrying the unit to its new location.
●Your furniture can be disassembled and
reassembled
to move.
● Clean the product with a soft damp cloth. DO NOT
use harsh chemicals or abrasive cleaners.
● Check all bolts, screws and fasteners periodically
and tighten them if necessary.
Keep away from heat to avoid glazing, melting or burning of components.