Dorel Living DL7891G-1 User manual

Model Number: UPC Code: Color:
DL7891-1
0-65857-17796-1 Mocha
DL7891
0-65857-17942-2 Mocha
DL7891W-1
0-65857-18284-2 White
DL7891W
0-65857-18283-5 White
DL7891G-1
0-65857-19465-4 Gray
DL7891G
0-65857-19464-7 Gray
DL7891B-1
0-65857-19900-0 Black
DL7891B
0-65857-19899-7 Black
Date of Purchase: _____ / _____ / _____ Lot Number:
(taken from carton)
TWIN
BUNKBED
For more great furniture ideas, check out our website at www.dorelliving.com
You can also keep up to date on all the latest trends by liking our Facebook page.
DO NOT RETURN PRODUCT TO THE RETAILER. If a part is missing or damaged, contact
our customer service department. We will replace the part FREE of charge.
NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Customer satisfaction is important to us at Dorel Asia. Our agents are available Monday to
Friday 8am to 5pm (EST) to answer any question you may have. For faster service, always
have the model number ready when calling our toll free number 1-800-295-1980 or emailing
us at [email protected] .
ATTENTION
USE THIS
MANUAL TO
ASSEMBLE THE
TWIN BUNK BED

*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
PERIODICALLY CHECK AND ENSURE THAT THE GUARDRAIL, LADDER AND OTHER COMPONENTS
ARE IN THEIR PROPER POSITION, FREE FROM DAMAGE, AND THAT ALL CONNECTORS ARE TIGHT.
DO NOT ALLOW HORSEPLAY ON OR UNDER THE BED AND PROHIBIT JUMPING ON THE BED.
DO NOT USE SUBSTITUTE PARTS. CONTACT CUSTOMER SERVICE FOR REPLACEMENT PARTS.
USE OF A NIGHT LIGHT MAY PROVIDE ADDED SAFETY PRECAUTION FOR A CHILD USING THE
UPPER BUNK.
PROHIBIT MORE THAN ONE PERSON ON UPPER BUNK.
E-MAIL: [email protected]
WARNING
THE USE OF WATER OR SLEEP FLOTATION MATTRESSES IS PROHIBITED.
ALWAYS USE THE LADDER FOR ENTERING AND LEAVING THE UPPER BUNK.
THE MATTRESS PLATFORM IS DESIGNED TO SUPPORT A MATTRESS WITHOUT THE NEED FOR A
POSTURE BOARD OR BOX SPRING.
ALWAYS USE THE RECOMMENDED SIZE MATTRESS OR MATTRESS SUPPORT, OR BOTH, TO HELP
PREVENT THE LIKELIHOOD OF ENTRAPMENT OR FALLS.
USE ONLY COIL SPRING MATTRESSES ON BOTH THE UPPER AND LOWER BUNKS. FAILURE TO DO SO
CAN RESULT IN INJURY.
USE ONLY MATTRESSES WHICH ARE 74"-75" LONG AND 37 1/2" - 38 1/2" WIDE ON UPPER AND ON
LOWER BUNKS. ENSURE THICKNESS OF MATTRESS DOES NOT EXCEED 6". SURFACE OF MATTRESS
MUST BE AT LEAST 5" (127MM) BELOW THE UPPER EDGE OF GUARDRAILS.
DO NOT ALLOW CHILDREN UNDER 6 YEARS OF AGE TO USE THE UPPER BUNK.
ALWAYS USE GUARDRAILS ON BOTH LONG SIDES OF THE UPPER BUNK. IF THE BUNK BEDWILL BE
PLACED NEXT TO THE WALL, THE GUARDRAIL THAT RUNS THE FULL LENGTH OF THE BED SHOULD BE
PLACED AGAINST THE WALL TO PREVENT ENTRAPMENT BETWEEN THE BED AND WALL (APPLICABLE
FOR BUNK BEDS WITH FULL LENGTH GUARDRAILS ON ONE SIDE).
STRANGULATION HAZARD - NEVER ATTACH OR HANG ITEMS TO ANY PART BUNK BED THAT ARE
NOT DESIGNED FOR USE WITH THE BED; FOR EXAMPLE, BUT NOT LIMITED TO HOOKS, BELTS AND
JUMP ROPES.
FOLLOW THE INFORMATION ON THE WARNINGS APPEARING ON THE UPPER BUNK END
STRUCTURE AND ON THE CARTON. DO NOT REMOVE WARNING LABEL FROM BED.
CUSTOMER SERVICE
If you are missing parts or have any questions about this product, contact our customer
service representative first!
CALL 1-800-295-1980
You can also order parts by writing to the address listed below. Please include the
product model number, color and a detailed description of the part.
Customer Service Department No. 413
12345 Albert-Hudon Boulevard, Suite 100
Montreal, Quebec
Canada, H1G 3L1

*
*
*
*
*
*
*
*
*
*
WARNING: Should this product become damaged,
and/or components are broken or missing, DO NOT USE.
CARE AND CLEANING
Dust regularly with a soft, dry cloth. We do not recommend the use of chemical
cleaners or wax on our lacquered furniture as it may damage the finish. Keep
solvents, alcohol, nail polish and polish removers away from your hardwood
furniture surfaces.
MAINTENANCE
Check bolts/screws periodically and tighten them if necessary.
LIMITED WARRANTY
DOREL warrants its product to be free from defects in material and workmanship and
agrees to remedy any such defect. This warranty covers 1 year from the date of
original purchase. This warranty is valid only upon presentation of proof of purchase.
This is solely limited to the repair or replacement of defective furniture components and
no assembly labor is included. This warranty does not apply to any product which has
been improperly assembled, subjected to misuse or abuse or which has been altered
or repaired in any way. This warranty gives you specific legal rights and you may also
have other rights which vary from State to State
CAUTION: ADULT ASSEMBLY REQUIRED. ASSEMBLY WILL REQUIRE 2 PEOPLE. ESTIMATED
ASSEMBLY TIME 45 MINUTES.
ASSEMBLY WILL REQUIRE TWO PEOPLE.
MOST BOARD PARTS ARE LABELED OR STAMPED ON THE RAW EDGE.
PHILLIPS SCREWDRIVER (NOT INCLUDED) IS REQUIRED.
A RUBBER MALLET (NOT INCLUDED) IS RECOMMENDED TO FACILITATE ASSEMBLY.
BED IS DESIGNED FOR CHILDREN RANGING FROM 6 YEARS OF AGE TO YOUNG TEENAGERS.
CAUTION: ADULT ASSEMBLY REQUIRED
MAKE SURE ALL PARTS ARE INCLUDED. WORK IN SPACIOUS AREA, PREFERABLY ON A SMOOTH
SOFT SURFACE.
KEEP THESE INSTRUCTIONS FOR FUTURE USE.
NOTES
READ EACH STEP CAREFULLY BEFORE STARTING. IT IS VERY IMPORTANT THAT EACH STEP OF
INSTRUCTION IS PERFORMED IN THE CORRECT ORDER. IF THESE STEPS ARE NOT FOLLOWED IN
SEQUENCE, ASSEMBLY DIFFICULTIES WILL OCCUR AND CAN RESULT IN INJURY.

HARDWARE LIST
1 2
3 4
5 6
7 8
910 11
METAL DOWEL
4 PCS
FLAT HEAD SCREW
6 PCS
16 PCS
2 PCS
2 PCS
HEX CAP
JOINT CONNECTOR (4mm HEX HEAD)
BARREL NUT
Φ 6.5mm x 100mm
Φ 4mm x 35mm
Φ 10mm x 100mm
Φ 4mm x 30mm
WOOD JOINT CONNECTOR (4mm HEX HEAD)
24 PCS
FLAT HEAD SCREW
24 PCS
JOINT CONNECTOR (4mm HEX HEAD)
16 PCS
WOOD JOINT CONNECTOR (4mm HEX HEAD)
10 PCS
TWIN BUNK BED
Φ 1/4" x 100mm
Φ 6.5mm x 48mm
Φ 11.8mm x 15mm
Φ 1/4" x 32mm
Φ 9mm x 17mm
Φ 10mm x 50mm
WOOD DOWEL
62 PCS
ALLEN KEY
1 PC

PARTS LIST
A B C
D E F
2 PCS
2 PCS
4 PCS
TOP POST
1 PC
TOP POST
2 PCS
TOP POST
1 PC
BOTTOM POST
BOTTOM POST
TWIN BUNK BED
HEADBOARD TOP CROSS
A
B
B
C
D
D
E
E
F
F
F
F
G
G
G
H
I
J
K
G
L
L
L
L
L
L
L
L
L
N
N
O
P
Q
Q
Q
S
S
S
T
T
U

PARTS LIST
G H I
J K L
M N O
P Q R
S T U
HEADBOARD CENTER CROSS
SLAT WITH WOOD DOWEL
GUARDRAIL POST
4 PCS
4 PCS
1 PC
RIGHT LADDER END
LADDER STEP
GUARDRAIL LEG
1 PC
3 PCS
2 PCS
1 PC
HEADBOARD BOTTOM CROSS
4 PCS
TOP FRONT SIDE RAIL
1 PC
SLAT WITHOUT WOOD DOWEL
BACK SIDE RAIL
BOTTOM BACK SIDE RAIL
2 PCS
2 PCS
TWIN BUNK BED
LONG GUARDRAIL
SHORT GUARDRAIL
LEFT LADDER END
BOTTOM FRONT SIDE RAIL
1 PC
1 PC
1 PC
12 PCS

NOTE: Be sure to use headboard top cross (F) with warning label attached to it is between
top posts (A) and (B). See the above illustration for label orientation.
Repeat this previous step to assemble the other headboard using posts (B & C).
TWIN BUNK BED
STEP 1
Insert wood dowels (7) into the ends of headboard top cross (F), headboard bottom cross
(G) and headboard center cross (S). Attach them to top posts (A & B) using wood joint
connectors (3) as shown. Tighten the wood joint connectors (3) with the Allen key (8).
NOTES: Headboard top crosses (F, G& S) may require that they be pulled closer together or
further apart in order to allow wood dowels (7) to align with holes in top posts (A & B).
3
A
7
7
7
7
7
7
7
7
C
7
7
7
7
7
7
7
7

TWIN BUNK BED
STEP 2
Insert wood dowels (7) into the ends of headboard top cross (F), headboard bottom
cross (G) and headboard center cross (S) and attach them to bottom posts (D) & (E)
using wood joint connectors (3) as shown. Tighten the wood joint connectors (3) with
the Allen key (8).
D
E
7
7
7
7
7
7
7
7
D
E
7
7
7
7
7
7
7
7
3

TWIN BUNK BED
Note: This is the lower bunk.
Attach the two headboards with bottom posts (D & E) to bottom front side rail (I) and
bottom back side rail (K) using joint connectors (1) and barrel nuts (9) as shown.
Tighten the joint connectors (1) with the Allen key (8).
STEP 3
K
I

STEP 4
TWIN BUNK BED
Insert wood dowels (7) into each end of the long guardrails (M).
Attach two long guardrails (M) and two top side rails (H & J) to top posts (A & B) and
(C & B) as shown.
Fasten top side rails (H & J) with joint connectors (1) and barrel nuts (9). Fasten long
guardrails (M) with wood joint connectors (3).
Tighten the joint connectors (1) and wood joint connectors (3) with the Allen key (8).
J
H