Drive Medical Sofia & Sienna User manual

Drive Medical, North Road, Bridgend Industrial Estate, Bridgend. CF31 3TP
RISER RECLINER ARMCHAIRS
Owners Manual

Introducon
Welcome to Drive Medical. You are now in possession of a Riser Recliner Armchair from one of the United Kingdom’s
leading Healthcare Companies. Our high quality chairs are manufactured in a choice of styles and fabrics.
The Soa , Sasha & Sienna are supplied with single motors. The Serena, Santana & Star are supplied with a choice of
single or double motors . All chairs except the Santana & Star are ed with an an entrapment facility as standard.
The baery back up system on our Riser Recliner Armchairs enables the chairs to be raised and lowered at least 3
mes, in the event of a power failure. Our Riser Recliners are CE marked and are ame retardant in accordance with
BS7176:2007 - low hazard. Protecve head & arm covers are provided on all chairs except Santana Leather.
RISER RECLINER ARMCHAIRS
Riser Recliner shown is
ed with a waterfall
Protecve head cover. Arm covers also
provided but not shown.
Handset holder
Lead from cable hub connects to
transformer below.
Side pockets on both sides of Riser Recliner Armchair
Single motor hand set
The external transformer should not be placed in the void area underneath the chair.
The transformer should be placed in an open area to reduce the potenal for the
cables to become damaged by the chair’s li mechanism. It is also recommended not
to place the transformer near a heat source or to cover the transformer.
The above image of Riser Recliner is shown without the an entrapment fabric ed.

RISER RECLINER ARMCHAIRS
Assembly Instrucons
1. Working at the back of the chair, une cable es and connect lead to the Transformer (g 1).
2. Remove cover and connect baeries to Transformer (g 2). Baeries can be found in side pocket of chair.
3. Plug into mains (g 3). Your Drive Medical Li & Recline Chair operates on standard household electric.
4. Remove handset from side pocket.
5. Before ng backrest, recline the chair via the handset .
6. Clip backrest onto base, ensuring both receivers lock into the brackets (g 4).
Operaon
To allow for sucient room for the backrest to recline, the chair must be placed at least 46cm (18”) at the rear from a wall or
surrounding furniture. Your Li-Recline Chair is operated by a hand control located on the right hand side of the chair.
The handset for the single motor chair has 2 buons (g 5). One will lower and recline the backrest and the other will raise
and incline the seat. The chair will only move when the selected buon is connuously pressed. To stop in any posion, simp-
ly release the buon. To recline the chair, press the “down” buon and hold, unl the backrest is in the required posion. To
raise the chair, press the “up” buon and hold unl the seat is in the raised posion. The handset for the dual motor chair has
5 buons.
The chairs are ed with an entrapment sensors around the underside of the chair (g 6). If the sensors become damaged in
any way then the chair may cease to funcon. Should this occur, then the spare plug (g 7), located in the baery bag, should
be ed into the TSS port in the control box under the chair (g 8). To do this the sensor plug from the cable hub should be
removed and the spare plug ed in it’s place. This will allow the chair to be raised or lowered to the original start posion.
This operaon is intended as an emergency operaon only and should not be repeated to connue the usage of the chair.
Should any damage to the sensors occur then the chair should be removed from use and advice sought from a Drive Medical
approved retailer.
On receipt of your riser recliner armchair, you will be in possession of the following parts:-
Seat base, backrest, transformer, handset, baeries, head & arm covers.
(g 1) (g 2) (g 4)
(g 8)
(g 3) (g 6) (g 7)
TSS Port
(g 5) Note:- If the riser recliner does not operate, check thoroughly that the above assembly instrucons have
been administered.

RISER RECLINER ARMCHAIRS
Cauon
When raising the chair seat, always keep your feet in contact with the ground. Do not operate the chair unless you are certain
there are no children or pets anywhere near or at the rear of the chair. Do not allow any liquids to come in contact with the
hand control and any spilt drinks or uids on the seat are to be immediately removed to avoid possible contact with the elec-
trics underneath. Remove power supply immediately.
Baery Back-Up Supply
In the event of a mains power supply failure, your chair will automacally be operated from the baery supply system. The
baeries should be ed to the transformer. They will not be connected at me of shipping from Drive Medical. Please en-
sure that the baeries are connected to the transformer, before use and that they remain connected. Replacement baeries
can be sourced from your local shop or supermarket and we advise you to replace them every two years or immediately aer
use to ensure adequate supply of power in the event of a mains supply failure.
An Entrapment Facility
All Drive Riser Recliners except Santana & Star are ed with a built in an entrapment system. The scissor acon is covered
with fabric prevenng small children or pets crawling through the mechanism. In addion, there are sensors under the base
of the chair. When the chair is being lowered to the ground, should there be an obstacle underneath the base, the chair will
automacally stop and raise. It will only lower if the area beneath the sensors are clear.
Maintenance and Cleaning
You chair does not require any roune or regular service. In the event of a fault, please contact your Supplier or local Drive
Medical Agent. The motor and folding mechanism requires no cleaning. The upholstery can be cleaned with slight sponging
of warm soapy water or domesc upholstery cleaning. Do not use bleach base cleaners to avoid discolouraon.
Warranty
The Drive Medical range of Li-Recline Chairs are warranted for two years from date of purchase against faulty workmanship
or materials on the frame, mechanics and electric controls. Note - Wear and tear on the upholstery is not covered. Please
contact your Supplier/Dealer should a fault occur. The warranty does not extend to the consequenal costs resulng from the
fault clearance, in parcular freight and travel costs, loss of earnings, expenses etc. The manufacturer will not accept respon-
sibility for any damages or injury caused by mis-use or non-observance of the instrucons set out above.
Disposing of the Riser Recliner Armchair
The chair consists of metal and plasc components, electrical components, electrical cables and baeries. Disposal of the indi-
vidual materials must be carried out in accordance with environmental and disposal regulaons in the relevant country, and
may only take place aer the riser recliner chair has been dismantled. To dismantle the chair and to separate and dispose of
the materials, you would be advised to hand it over to your Specialist Dealer. Baeries may not be disposed of in domesc
waste, and must be disposed of according to naonal guidelines.
Models Motor Fabrics Available Max. User
Weight
Soa & Sienna Single Cinnamon, Mocha, Oatmeal or Floral 115 Kg
Serena Single Cinnamon, Mocha, Oatmeal, Floral
(wine vinyl in waterfall back only)
160 Kg
Serena Deluxe Dual Cinnamon, Mocha, Oatmeal or Floral 160 Kg
Sasha Single Oatmeal or Floral 115 Kg
Santana Single or Dual Oatmeal, Chocolate or Cream Leather 160 Kg
Star Single or Dual Oatmeal, Green or Red 115 Kg
Dealer Stamp:-
Email: [email protected].uk
D/N: N1-069-09