INSTALLATION MANUAL
DM Series video door phones
Page: 8
Check the WIFI coverage
Before placing the product in its final location, remember that this device must connect to your wifi network in order to function. You
should therefore check with your mobile phone that the point where you want to put it there is good coverage of your wifi network. If
you see that the signal is poor you should intervene on your wifi network, perhaps enhancing it with a repeater.
Do not install the product in an area with poor wifi signal as it would then be unreliable in its operation.
SD card
Smart-Home video intercoms can record the video on a micro SD card (not included) that you can insert inside. The SD card slot is
located behind the rear door, near the battery compartment. You can insert any Class 10 SD card with capacities up to 128GB.
Power on
These video door phones do not have a power switch. To make them work you have to open the rear door and remove the plastic
protection that insulates the batteries.
Inside the door you will also find the slot to insert the microSD card, the USB socket for charging and the RESET button.
Reset
Smart-Home devices are always equipped with a reset button that you can find behind the protective flap. Press and hold this button
for a few seconds if you want to restore the factory conditions to pair the video door entry unit to a new wifi network. A voice
message alerts you to the reset in progress.
You must perform this reset if you want to connect your camera to a new access point, even within your own LAN network.
DSE SRL - ITALY - WWW.DSE.EU
