INSTALLATION MANUAL
RT SERIES IP SPEED DOME CAMERAS
Page: 6
MOUNTING THE CAMERA
Cameras supplied with a wall bracket must be fixed to the wall with the supplied mounting bracket.
The connecting cable comes out through the bracket. The cable entry can be provided at
center of the bracket if the cable passage is walled up. Alternatively, an entrance is available
lateral.
Cameras without wall brackets are mounted directly to the ceiling by screwing the
metal disc of the base and then hooking the camera to the disc with a half turn of
locking.
The housings of all cameras in this range are watertight and can be mounted in
external. However, the connections must be protected from bad weather in special boxes
watertight.
ASSEMBLY FOR HUMAN DETECTION AND AUTOTRACKING
These cameras support human detection and autotracking. Thanks to
Human Detection The camera can detect whether a human person, not an animal either
object, moves in the frame. With autotracking the camera, in addition to detecting the
person, follows their movements.
Unlike normal motion detection, these detections can work too
if the camera is kept moving, for example by using a tour.
You can enable these features via the app, in the camera settings, such as
we will see later. In case of detection, the camera can trigger alarm actions
such as sending email / ftp, local sound alarms and push notifications. It is also possible to spread
a personalized warning message to give information or to discourage the intruder.
To make the best use of human detection you need to install the camera while holding in
consider the following chart. Note that the camera cannot detect the figure
human if it is too far below the camera.
The maximum shooting distance varies depending on the camera model and the power of the
zoom.
DSE SRL - ITALY - WWW.DSE.EU
