DTS Icom1000 Operator's manual

1
Base plate-mounting instructions
E-EEEE
DTS Icom1000
GSM Intercom
Users Instruction Manual
DTS SECURITY
P.O.BOX 3399
EDENVALE
1610
Spartan [phone]
Pretoria [phone]
www.dtssecurity.co.za

2
Main features
1000 station GSM Intercom with simple unit number keypad calling.
Up to 4 recipient names per unit can be selected to call from the LCD display.
Auto 60 second call hang-up with 10 second beep warning.
DTFM gate opening by call recipient (Press 9 on phone keypad).
Missed call Access control of up to 1000 registered users.
Gate alarm SMS to programmed recipients.
Optional 7 day activity log reporting.
Compatible with most GSM networks (Quad band).
Operates from an 8 to 32VDC supply (Battery backup recommended).
Vandal resistant & weather proof stainless steel housing (IP53).
Technical Specifications
Quad-band 850/900/1800/1900MHz
GPRS Multi-slot Class 12’1~12 configurable
GPRS Mobile station Class B
Compliant to GSM Class 4
Phase 2/2+ (2W @ 850/900MHz)
Class1
(1W @ 1800/1900MHz)
Speaker 4ohm, 60mm Dia., (Waterproof Cone)
Audio 2W RMS (1% Distortion)
Microphone 10mm Dia., Electret (Echo cancellation)
Supply voltage range 8.0 t0 32VDC (12/24V nominal)
Operation temperature -10ºC to +60ºC
Dimensions 135Width x 240 Height x 100mm Depth
Mounting Wall or Gooseneck pole
Visitor Operation
1. The visitor will enter the complex unit or house number on the keypad and press the
“#” key to enter. The system will search for up to 4 numbers registered to the entered
unit number and sequentially display the resident names on the LCD display. The
visitor can press the “#’ key again to call the displayed name or use the “0” key to
sequentially step through each registered name (if the unit number has only one
registered name then that name will be called on the first “#’ key press).
Note that the keypad entry will be cancelled if not entered within 20 seconds.
2. The calling ring tone will be audible from the intercom speaker (the call will be
cancelled if not answered within 30 seconds). When the resident answers the call the
visitor will have up to 60 seconds to speak to the resident. The resident can open the
gate for the visitor by pressing key “9” on his/her cell or landline phone. A warning
beep will be sounded 10 seconds before the 60 second cut-off time. The call will be
cancelled by the visitor pressing the “*” key or the resident hanging up.

3
Resident Operation
1. Up to 1000 permanent and temporary access names and telephone numbers can be
registered with the Icom1000 system for time and day limited or unlimited access. A
registered resident or employee can open the gate by calling the Icom1000 unit. The
call will not be answered and hang up on the first ring (as the call is not answered the
operation is free).
2. The gate alarm input can be configured to send a customised SMS alarm or warning
message to up to 6 recipient numbers.
3. All device configuration and access list maintenance can be performed by using the
free “My Gcom” portal at www.gcom500.co.za or by sending SMS command
messages. Note that any data entered or changed on the “My Gcom” manager portal
will overwrite any SMS entries; it is for this reason that we recommend using the
portal only for devices with more than 20 users. A list of SMS configuration and
programming commands can be found on the “My Gcom” portal.
Installation
To avoid problems cause by static discharge the intercom unit should be well earthed. To
be effective, earth connections should be made with a minimum 2.5mm² copper wire to a
ground point within 3 meters of the intercom. The ground point must be at an electrical
panel, a metallic cold water pipe that runs in the earth, or a grounding rod driven at least 2
meters into the soil. A gooseneck mounting post anchored in concrete does not make a
good ground. To allow for installation and maintenance the intercoms “tamper alarm” is
armed on the 1st keypad operation. GSM signal strength can be viewed by entering code
#00100 on the keypad (reverts to normal display after 60 seconds).
Wiring & Indicating LEDs

4
Antenna Connection
The Icom is supplied with a weather proof blade antenna with 1.5 meters of cable. To
avoid DTMA noise (buzzing sound on audio) the antenna should me mounted outside of
the steel enclosure and at least 1 meter away (possibly low down on the rear of the
gooseneck). Do not coil up loose antenna cable inside the housing.
Push-Push SIM Card Location
Icom1000 Warrantee
All goods manufactured by DTS Security Products carry a 24 month factory warranty
from date of invoice.
All goods are warranted to be free from faulty components and manufacture. Faulty
goods will be repaired or replaced at the sole discretion of DTS Security Products, free
of charge.
This warranty is subject to the goods being returned to the premises of DTS Security
Products.
This warranty excludes lightning damage, insect damage and damage caused by faulty
installation.
In the event of the goods being supplied by dealer, merchant, agent or duly appointed
installer of DTS Security Products, the claim must be directed to that supplier.
The carriage of goods is for the customer’s account.
This warranty is only valid if the correct installation and application of goods, as laid out
in the applicable documentation accompanying said goods, is adhered to.
All warranty claims must be accompanied by the original invoice.
The liability of DTS Security Products and / or their distributors is limited as herein set
out by DTS Security