Duratool D00374 User manual

Bench Soldering Fume Absorber 230V
Model: D00374

IMPORTANT SAFETY INFORMATION
When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory, or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
• This appliance contained no user-serviceable parts. All repairs should only be
carried out by a qualied engineer. Improper repairs may place the user at risk of
harm.
• Do not operate the appliance with a damaged plug or cord, after a malfunction or
after being dropped or damaged in any way.
• The supply cord cannot be replaced. If the cord is damaged the appliance should
be scrapped.
• Do not expose to rain or moisture.
• Do not use the appliance for any purpose other than that for which it is designed.
Please read these instructions carefully before use and retain for future reference.
PRODUCT OVERVIEW
OPERATION
SPECIFICATION
• The fan is designed to sit on a desktop.
• 3 active carbon bre lters are included.
• Low noise and long life service fan.
• Ensure the carbon lter has been inserted by un-clipping and lowering the guard
and placing the lter against the louvres and closing the guard.
• Plug the fan into a mains power outlet.
• Activate the on/off switch on the top of the unit and face the shrouded side towards
the solder smoke.
• The angle can be adjusted by loosening the locking wheels at each side and tilting
the fan as required then re-tighten the locking wheels.
• Under regular use, replace the lter every month. Replacement lters are available,
see our website or catalogue.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area. Made in China. PR2 9PP
Man Rev 1.0
Power 220-240V~50Hz 23W
Dimensions H x W x D 220 x 270 x 160mm
Weight 1.6kg