DURHAND B20-065 User manual

B20-065
EN

Insert inside edge
plate again, pay
attention to must first
after inserting plate,
the plate bending part
up
1. 2.
3.
5.
4.
6.
Fixed wheels
2 pcs
Wheel with brake 2 pcs
Bottom tray
(Bottom tray
has a hole)
Hex bolt connection
parts assembly sequence:
1 First casters with chassis connection at the bottom of the chassis with casters hole, directional
casters with casters on both sides can not be on the same side. Using a hex bolts
2 groups turn column, the column with the intermediate plate using a round head screw connection;
the difference between the plate and on the disc, there is a hook on the bottom of the dish, the dish
did not. Simply install the first disc
3 Install the left and right panels according to figure
4 assembly left and right side panels and the rear plate, note the installation order and direction of
the side plate as shown
5 fixed around the side plate and the rear plate, and then the upper plate installation, do not install
screws on the right and the need to install push hands together. Then pull the rails, and slide the
drawer and insert aligned, push the drawer in place to complete the assembly.
1 pcs handle
Drawer
Post 4 pcs
Middle tray 1 pcs
Column and round plates using
cross recessed screw connection
Screw round outward
Bottom tray
Side panels
After the first addition plate
inserted upright Rear plate
After the first addition
plate inserted upright
A left sideboard
To connect with the hand
screw through push from
the inside dish
Slide out of alignment
slide drawer, push the
drawer to
Installation diagram
Installed on the disk
Note the disk has a
hook on the right
hand screw and push
fitted together
Hook frontward
Note that when you
install a hook on the
bottom of the basin,
while the disc is not,
can not be installed
wrong