Dynalink X2810 User manual

X2810
Electronic OPEN / CLOSED Sign
with Remote Control
Installation Instructions
IN THE BOX
• Sign panel
• Remote control
• 5V Power adaptor
• Chain for hanging sign
STEPS
1. Install chain on both sides of two top rings first.
2. Hang on a 10kg minimum weight suction-cup hook or similar fixing method to hold the OPEN/CLOSED sign at the entrance to your premises.
3. Plug in 5V power plug and switch power on.
4. Follow the guidelines as below.
GUIDELINES FOR OPERATION:
There are four modes of operation:
1. OPEN STATIC
2. OPEN FLASHING
3. CLOSED STATIC
4. CLOSED FLASHING.
Note: The operation of the remote control takes precedence and overrides the operation of the panel switches. With the FLASH switch to ON position,
the remote control can be used to change to static operation by pressing the STATIC button. With the MODE switch to ON position, the sign will display
OPEN, but the remote control can be used to change the sign to read CLOSED. However, if the main POWER switch on the rear panel is off, then the
unit will not function and the remote control cannot switch it on.
If you want to… Program the operating mode by switches on
rear of the panel, press:
Program the operating mode by remote
control, press:
Switch on the panel POWER to ON position ON/OFF
Switch off the panel POWER to OFF position ON/OFF
Flash the word FLASH to ON position FLASH
Static the word FLASH to OFF position STATIC
Display OPEN MODE to ON position OPEN
Display CLOSED MODE to OFF position CLOSED

*The remote control IR receiver is located on the front of the sign. Therefore an operator must face the OPEN/CLOSED sign to operate it with the
remote control.
To remove battery, slide open door.
SPECIFICATIONS
Rated Voltage: .................................................................................................................................... 5V 2A
Power Consumption: ...................................................................................................................... 10 Watts
Operating Temperature: ................................................................................. -25 up to +65 degrees Celsius
Operating Mode: ......................................................................... Toggle switches for Power, Mode and Flash
Remote Control Battery: ............................................................................................. CR2025 3V (supplied)
Dimensions: ................................................................................................................... 174 x 410 x 55 mm
For repair or service please contact your place of purchase.
Note: Under no circumstances should you attempt to repair the device yourself or via a non-authorised Altronics service centre, as this will
invalidate the warranty!
During the warranty period, we undertake to repair or replace your product at no charge if found to be defective due to a manufacturing fault. The
warranty excludes damage by misuse or incorrect installation (i.e. failure to install and operate device according to specifications in the supplied
instruction manual), neglect, shipping accident, or no fault found.
NOT FIELD SERVICEABLE.
Distributed by Altronic Distributors Pty. Ltd.
Phone: Phone [phone] Fax: [phone]\
www.altronics.com.au