Dynapac BG39 Series User manual

DYNAPAC
CONCRETE EQUIPMENT
BG39/49 Power Floats
LONG OPERATING HANDLE ASSEMBLY INSTRUCTIONS BG39/49- I – 10659-1-ENG

2
ASSEMBLY INSTRUCTIONS
- Take-off the 4 nuts delivered on the complete base . Put in place base 1, holder cpl. 2, hand screw the nuts and
the screws then tighten them .
1
2
- Set in place the complete operating handle tanks to holder 3. Do not forget lifting eye 4and to introduce stay
upper 5into stay lower 6 .
5
4
3
6

3
- Connect blade angle cable 7on the fork , clutch cable 8 and throttle cable 9.
7
8
- Slide the protective hose 11 on the base electrical cable 10 . Connect the terminals . Slide the protective hose on
the terminals .
11
10

4
- Fasten the cable together using supplied clamps 13 (A clamp each 120 to 130 mm) . Start from the control box
and finish by fastening the cables on the lifting eye .
13
TEST
ALWAYS HAVE THE THROTTLE AT IDLE WHEN STARTING ENGINE
- Test the machine for proper operation .
Check :
- ON/OFF Switch
- Throttle control idle and full speed .
- Blade angle adjustment .
- Dead man handle .

5
DYNAPAC CONCRETE EQUIPMENT
DYNAPAC Concrete – HQ address: P.O Box 48 – 77220 Tournan-en-Brie, France, Tel:[phone], Fax: + 33.1. 64.42.00.04
Factory address : P.O Box 63, Route de Neville, 76460 Saint Valery-en-caux, France, Tel: [phone], Fax: [phone]
We reserve the right to change specifications without notice. Photos and illustrations do not always show standard versions of machines.
The above information is a general description only, is not guaranteed and contains no warranties of any kind.
www.dynapac-concrete.com