e-mo M12 User manual
0.0000
00
0
Mph
Km/h
KmODO
TRIP Mile
1. Brake handle
2. Headlight
3. Speed grip
4. Cruise
5. Fault code
6. Speed
7. Throttle
8. Gear
9. Trip(One-way mileage)
M12 scooter display instruction
1. Switch on and off
In the off state, press and hold the power button for 2 seconds to turn on.
In the on state, press and hold the power button for 2 seconds to turn off.
When turned on, the left and right lights will flash.
2. Gear switching
Press the gear plus button, the gear will increase by 1, up to 3
Press the gear minus button, the gear will decrease by 1, lowest to 1
3. Headlight
Press the middle power button shortly to switch on and off the headlights.
The headlights are on, the icon is on, the headlights are off, and the icon is dark.
4. Speed display
The speed can be displayed normally, how much the speed is, how many the speed number is on.
When there is speed, the speed grip icon will breathe.
5. Throttle
Press the throttle to drive
6. Brake
Press the brake to stop the scooter and the brake light will flash.
7. Battery power
Above 40v is 5 grids;
Above 37.5v is 4 grids;
Above 35.5v is 3 grids;
Above 33.3v is 2 grids;
Above 32.2v is 1 grid;
Lower 31.1v 0 grid, the power icon is flashing.
10. ODO (total mileage)
11. Mileage
12. Gear plus button
13. Power button
14. Gear minus button
15. Mile
16. KM
17. Battery power
8
10
9
11
12 13 14
15
16
17
2
7
13
4
5
6
8. Fault code
9. Function settings
Press and hold the gear plus button for 2s to enter the setting mode.
In setting mode state, short press gear plus button to switch setting items, short press gear minus to switch function
P0 switch mile/km;
P1 switch TRIP / ODO;
A0 does not cruise, A1 cruises;
b0 zero start, b1 non-zero start.
Press and hold the gear plus button for 2s to exit, or exit without operation for about 40s.
10. Forced shutdown and automatic shutdown
Press and hold for 8s to force shutdown.
No operation for 10 minutes to automatic shutdown
11. Cruise and Assisted start
Keep the throttle for about 6s to enter the cruise. The cruise icon lights up and the buzzer sounds. Assisted start,
the motor will start at a initial speed, otherwise it will not start.
12. Current limiting
Motor current limit 16A.
13. Speed
14. Buzzer
There is music when scooter is on and off. There are sounds when you press the plus and minus keys and turn on the
headlights. When the battery is low, the buzzer sounds 5 times.
Code
E1
E2
E5
E6
E7
E8
Failure
Communication failure
Hall fault
Voltage is too low (31V)
Stall protection
Throttle abnormal or speeding
Hardware overcurrent
Gear
1
2
3
Speed (KM / H)
10
15
20
