eaglelighting INDIGO COMBO T5 User manual

IMPORTANT INFORMATION
Please read this guide carefully before
installing or maintaining this equipment.
Data should be used as an INDICATION only.
▪Good electrical pracces should be followed
at all mes.
▪Must only be installed by a licensed
electrician.
▪If the external exible cable or cord of this
luminaire is damaged, it shall be exclusively
replaced by the manufacturer or their
service agent or a similar qualied person in
order to avoid a hazard.
▪For indoor use only.
▪A qualied electrician, in accordance with
AS/NZS 3000:2007 wiring regulaons
should carry out connecon to mains
wiring.
▪This unit must be EARTHED.
▪Ensure that the rated voltage and frequency
requirements are compable with the
available mains supply, 220-240V 50Hz.
▪Cleaning of reectors and lenses should be
carried out using clean, so and lint free
cloths and an-stac cleaning uid.
▪Do not carry out high voltage insulaon
test i.e. 500/1000V this may damage the
xtures electrical components.
Warning - Applicable to New Zealand (Only)
This luminaire is not suitable for installaon in
locaons where thermal insulaon is present,
or may reasonably be expected to be installed
in the future, or where there is a likelihood of
other combusble material, e.g. Leaves or vermin
debris, etc. collecng on or around the luminaire.
It is not suitable for domesc installaons or
installaon in residenal areas of non-domesc
installaons (residenal instuons, hotels,
boarding houses, hospitals, accommodaon
houses, motels, hostels and the like).
Luminaire’s light distribuon is direct.
Luminaire is designed for the T5-light source’s unique
characteriscs. The small diameter of the uorescent lamp
has created new condions for light control.
IP20
IP CLASSIFICATION
IP20 : Protected against solid objects greater than 12mm.
e.g. Persons ngers.
CLASS I
Appliances with funconing insulaon. Equipped with an
earth terminaon.
RISK OF FIRE
a. The minimum clearance distance from the top of the
luminaire to any normally ammable building element
is 100mm.
b. The minimum clearance distance from the top of the
luminaire to any building insulaon is 100mm.
c. The minimum clearance distance from the side of the
luminaire to any normally ammable building element
is 100mm.
d. The minimum clearance distance from the side of the
luminaire to any building insulaon is 100mm.
WARNING – RISK OF OVERHEATING OR FIRE IF THE
CLEARANCE DISTANCES ARE COMPROMISED.
Luminaire is available in designs for convenonal emergency
lighng operaon.
RCM
Indicates a device’s compliance with applicable ACMA
technical standards.
INSTALLATION INSTRUCTIONS
INDIGO COMBO T5
SPECIFICATION
CODE INS-IND5
MELBOURNE | 17-19 Jets Court. Melbourne Airport. VIC 3045 P.03 9344 7444 F.03 9344 7433
SYDNEY | Unit 4, 21 Mars Road. Lane Cove. NSW 2066 P.02 9420 5799 F.02 9420 5988 BRISBANE | 53 Caswell Street. East Brisbane. QLD 4169 P.07 3891 0744 F.07 3891 0755

EXPOSED T-BAR
Step 1
Li the luminaire into the ceiling cavity.
Step 2
Complete the electrical connecon.
Step 3
Posion the luminaire centrally within
the T-Bar.
PLASTER CEILING
Step 1
Cut out the correct hole size in the
ceiling for your plaster frame accessory.
Step 2
Li the plaster frame to the plaster
cut out.
Step 3
Fold over the retaining tabs located
in the ends of the frame to assist in
securing the frame.
Step 4
Fasten the recessing brackets to the
secure the frame within the ceiling cavity.
Step 5
Li the luminaire into the ceiling cavity.
Step 6
Complete the electrical connecon.
Step 7
Posion the luminaire centrally within
the Plaster frame.
SURFACE MOUNTED
Step 1
Li the surface mounted body to
the ceiling, feeding the supply cable
through the cable entry hole.
Step 2
Secure the body onto the mounng
surface with appropriate fasteners (not
supplied) to suit the mounng substrate.
Step 3
Complete electrical connecon.
Step 4
Slide the luminaire into the surface
mounted body and connect the earth
lanyard to the end.
Step 5
Slide the end into the surface mounted
body.
INSTALLATION INSTRUCTIONS
INDIGO COMBO T5
CODE INS-IND5
MELBOURNE | 17-19 Jets Court. Melbourne Airport. VIC 3045 P.03 9344 7444 F.03 9344 7433
SYDNEY | Unit 4, 21 Mars Road. Lane Cove. NSW 2066 P.02 9420 5799 F.02 9420 5988 BRISBANE | 53 Caswell Street. East Brisbane. QLD 4169 P.07 3891 0744 F.07 3891 0755