Earthworks SR40V User manual

User’s Guide
SR40V
Handheld High Definition
Vocal Microphone™
earthworksaudio.com
Product Registration
To help you get the most out of your Earthworks purchase, please take a moment and
register your product with us online at earthworksaudio.com/register.
Service & Repair
If you have any problems with your Earthworks products, please contact our Service &
Repairs Department.
Email: [email protected]
Telephone: [phone], ext. 119
Printed in USA
MADE IN USA
July 11, 2018

Description
Avoid extreme heat and condensing humidity. Allow the microphone to warm up
in the case when bringing it in from the cold weather.
Rough handling may damage the microphone even if no visible marks are left.
When not in use keep the SR40V in its case.
•
•
•
Specications
Frequency response: 20Hz to 40kHz
Polar Pattern: Hypercardioid
Sensitivity: 10mV/Pa (-40dBV/Pa)
Power Requirements: 24-48V Phantom, 10mA
Peak Acoustic Input: 145dB SPL
Output: XLR-3
Output Impedance: 65Ω, balanced between pins 2 & 3
Minimum Load: 600Ω btw. pins 2 & 3
Noise: 20dB, A equivalent
Dimensions L x D: 7.25 in. (184mm) long
max diameter 1.95 in. (55.3mm)
min diameter .97 in. (27.5mm)
Weight: 363g (12.8 oz.)
XLR Output Connector Assignment of SR40V
Impulse Response of SR40V (typical)
Polar Response of SR40V (typical)
Frequency Response of SR40V (typical)
SR40V
The Earthworks SR40V is a directional pre-polarized
condenser microphone with a rst-order hypercardioid
pickup pattern directly coupled to a dedicated
wide band, low output impedance transformerless
preamplier. The SR40V requires standard 24-48V
Phantom Power. It features a frequency response
from 20Hz to 40kHz, fast impulse response, very low
handling noise, near-perfect polar response, and high SPL handling. The SR40V is
excellent in rejecting sounds at the rear of the microphone and providing more gain
before feedback in live sound applications.
Each SR40V microphone is thoroughly tested and measured to ensure it meets its
exceptional specications. A mounting clip is included with the microphone.
Applications
The Earthworks SR40V is easy to operate. Connect the microphone to a microphone
preamplier supplying 24-48V phantom power using a standard XLR microphone cable.
Please allow up to one minute for the microphone to settle. Plugging in the microphone
“hot” (phantom power already present at the input) will not damage the microphone,
and is actually preferred for faster settling. It is normal for any phantom powered mic
to cause a “pop” in the audio or recording system when initially plugged in or powering
up. Make sure to mute the signal to speakers or headphones when phantom power is
rst applied to the microphone.
The excellent performance of the SR40V make it an exceptional vocal microphone in the
studio or on the stage, and is an ideal choice for vocals, voice-overs and instrumental
applications. The SR40V’s extended frequency response, fast impulse response
and short diaphragm settling time allow it to capture explosive performances while
preserving the subtle nuances of artistic expression. It is excellent in rejecting sounds
from the rear of the microphone and providing more gain before feedback in live sound
applications.
Care of Microphone
The Earthworks SR40V microphone is a precision instrument designed and built to
provide years of top performance. Following these simple rules will help to protect your
investment in the SR40V:
Specications are subject to change without notice.
Pin 1
“Shield”
Pin 2
“+”
Pin 3
“-”