Eastwood 33935 User manual

RECHARGEABLE
COB LED PALM LIGHT
INSTRUCTIONS
© Copyright 2020 Eastwood Automotive Group LLC 11/20 Instruction item #33935Q Rev 1
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: [e-mail]
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
Item #33935
OPERATION
• Fully charge the Light before use.
• Grip the lamp housing and rotate Magnetic
Base through 180° (FIG 1).
• Place the base against any ferrous metal
surface for magnetic attachment.
• Release Retractable Swivel Hook to hang from
overhead objects.
• Depress and release round Button located at front of Housing once for High-Intensity
COB LED Illumination, 2nd time for
Low-Intensity COB LED Illumination and a 3rd time for the Flashlight (FIG 1).
• Depress Button once again to turn off.
CHARGING
• When the Indicator light above the Charging
Port illuminates RED, the battery requires a
charge. To do so:
- Flip up rubber seal and plug the Micro-
USB terminal of the included Power Cord
into the Micro-USB port on the side of the housing (FIG 2).
- Plug the USB terminal of the Power Cord into the USB output port of the included 120VAC
to 5V 1A Charger.
- Plug wall unit into properly grounded 120 VAC, 60 Hz. outlet.
- Allow 2.5 hours for full charge.
- Do not use Light while charging.
- The Indicator Light above the Charging Port will flash RED while charging then change to
GREEN indicating full charge (FIG 2).
- Close Charging Port Cover to maintain IP-20 rating.
- Do not leave Light on charge beyond 24 hours.
Batteries will automatically discharge without use and must be charged every
3 months even if the light has not been used.
Do Not charge batteries in temperatures below 40°F [4.4°C].
FIG. 1
FIG. 2

2Eastwood Technical Assistance: 800.343.9353 >> [e-mail]
CONTENTS
(1) Eastwood Rechargeable COB LED Palm light with
adjustable magnetic base.
(1) Wall Charger – 120V input, 5VDC, 1A output wall
charger with USB Port
(1) 39” [1.0m] USB to Micro USB Cord
SPECIFICATIONS
• 3.7 Volt, 1400mAh, Li-Poly Integral
Rechargeable Battery
• Light Output (In Lumens)
- High COB Worklight = 320 Lumens
- Low COB Worklight = 160 Lumens
- LED Flashlight = 60 Lumens
• Working time (In Hours)
- High COB Worklight = 2.5 Hours
- Low COB Worklight = 5 Hours
- LED Flashlight = 6 Hours
• 2.5 Hour charge time
• IP20 Moisture Resistance rating
FEATURES
• Four-function Switch:
- Press once and release, On, High Intensity COB LED Illumination
- Press again and release, Low Intensity COB LED Illumination
- Press again and release, Flashlight Illumination
- Press again and release, Off
• Magnet at Base with 180° pivoting adjustment
• Retractable Hook in rear of Housing
To order parts and supplies: 800.343.9353 >> eastwood.com 3
LITHIUM BATTERIES STORE A LARGE AMOUNT OF ENERGY AND WILL ERUPT
IN FLAMES OR VIOLENTLY EXPLODE IF NOT PROPERLY HANDLED.
READ INSTRUCTIONS
• Thoroughly read and understand this manual before using.
• Save for future reference.
SERIOUS INJURY, FIRE & EXPLOSION HAZARD!
• Keep Dry – Do Not open unit, drop, short circuit, incinerate, expose to
temperatures greater than 140°F [60°C].
• Do Not charge or use if damaged.
• Do Not submerge lamp.
• Do Not operate in explosive atmospheres such as explosive vapors,
flammable liquids, gasses or dust.
• Not a toy. Keep out of the reach of children.
• Charge lamp only according to these instructions.
EYE INJURY HAZARD!
• DO NOT allow LED lamp to project directly into eyes. Temporary blindness
may occur.
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to personal injury.
SAFETY INFORMATION
The following explanations are displayed in this manual, on the labeling, and on all other information
provided with this product:
The EASTWOOD RECHARGEABLE COB LED PALM LIGHT utilizes the latest COB LED technology to
provide highly efficient, energy saving lighting. A four-position switch allows instant switching from the
low to high-intensity COB LED to the focused flashlight LED. A lightweight polymer housing with shock
resistant protection provides tactical level reliability. The convenient pivoting, magnetic mount design
allows for maximum flexibility and the USB Charging Port Power Cord offers go anywhere capability.