Eaton Halohome User manual

Reconfigure Internet Access Bridge WIFI
User Manual
Internet Access Bridge

2www.eaton.com/HaloHome
Halo Home User Manual
Internet Access Bridge
Important:
• Plug in the Bridge within 40 feet but not closer than 5 feet of the Wi-Fi Router you want to connect it to
• Make sure there is an HALO Home device with 60 feet of the Bridge
• When setting up the Bridge Wi-Fi with your phone,stand near the closest HALO Home Device to the Bridge, not the Bridge itself
• It may take up to 3 minutes for the Bridge to be visible to your network after it is plugged in
• You will need HALO Home app version 1.5.0 or later to use the Bridge
Reconfigure Internet Access Bridge WiFi
You may need to do this if:
• Your router is changed
• You want to connect your Bridge to a different wifi network
• Your wifi password has changed
• You have moved your Bridge to a different location
1. Navigate to the
Controllers list
and press the
orange arrow on
the right side of
the Bridge list item.
2. Press the button
at the bottom of
the Bridge settings
page to set up your
WiFiconnection.
3. Set up your Bridge
and assoicate to
your WiFi network.
4. Select the Wifi
connection you want
and press Next
Enter the
WiFipassword.

3www.eaton.com/HaloHome
Halo Home User Manual

Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
Product availability, specifications,
and compliances are subject to
change without notice.
Canada Sales
5925 McLaughlin Road
Mississauga, Ontario L5R 1B8
P: 905-501-3000
F: 905-501-3172
Eaton
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.eaton.com/connectedlighting
For service or technical assistance:
1-800-553-3879
© 2018 Eaton
All Rights Reserved
Printed in USA
Publication No. MN503043EN
February 16, 2018 4:14 PM
5. The Green LED
should glow solid
againafter the
connection