Ebmpapst EC Aura Troubleshooting guide

1
Operation and Maintenance Instructions
Operation and Maintenance Instructions for EC Aura 230V
Document no 210-OMI10013-40
Issue 5
Part No: COOL500EC-230
Manufacturer: ebm-papst UK Ltd
Stationary class 1 motor operated appliance with a fixed supply cord

2
Contents
Notice.................................................................3
1. Safety
2. Specification..............................................................................................4
3 Use of connection converter plug...........................................................4
3.1 General...................................................................................................4
3.2 Warning ..................................................................................................4
3.3 Removal of converter plug....................................................................5
4Operating instruction................................................................................7
5Maintenance..............................................................................................7
6WEEE (waste electrical and electronic equipment)..............................7
7End of life...................................................................................................7
8Take back policy.......................................................................................7
9Data sheet.................................................................................................9
10 Certificate of Conformity.....................................................................10
Figure 1 - EC Aura .................................................................... 4
Figure 2 –As supplied; converter plug fitted............................. 5
Figure 3 –loosening of screws of converter plug...................... 5
Figure 4 –releasing of the barbed clips or the top housing......6
Figure 5 - picture showing 'schuko' plug inside converter plug.6
Figure 6 - control panel sub assembly...................................... 8
Figure 7 - housing sub assembly.............................................. 8
Figure 8 - trolley sub assembly ................................................. 8

3
1.Safety Notice
WARNING
Danger of Electric Shock
The separate, supplied loose, connection converter
plug must be assembled correctly to avoid an electric
shock. Refer to Section 3 for fitting and use of the
converter plug
OTHER HAZARDS
Do not leave under 14 years old children near the
appliance unsupervised when appliance is in
operation
Do not push fingers or objects through guards
Keep guards clear from obstructions
Do not operate appliance in an explosive
atmosphere
If the supply cord is damaged it must be replaced
by the manufacturer or its service agent, or similarly
qualified person
Isolate the appliance by disconnecting the plug and
supply cord from the mains socket. The switch on
the appliance does not isolate the appliance
Do not move the appliance during operation.
Disconnect from mains supply before moving
Do not jet or power wash
OTHER CONSIDERATIONS
The mains plug is a disconnection device. The earth
bond resistance is nominally 0.16 ohms

4
2.Specification
This is a stationary Class I motor -appliance with a fixed supply lead
Manufacturer: ebm-papst UK ltd
Part number: COOL500EC-230
Voltage: 230 V 50/60 Hz
Current: rated for maximum 2.2 Amp
Ambient temperature: Maximum 55oC
Protection: IP54
Commission regulation (EU) 327|2011: the fan integrated within the appliance is part
number A3G500-AD01-51 and conforms to the requirement of the regulation.
Figure 1 - EC Aura
3 Use of connection converter plug
3.1 General
The appliance is supplied fitted with a supply cord and plug. The plug is a ‘schuko’
type plug to DIN VDE 0620 with a converter plug fitted over the ‘schuko’ plug for
connection to a standard UK socket to BS 1363.
If the appliance is to be used in a country that has mains socket suitable for use with
a ‘schuko’ plug then the converter plug can be removed with simple tools.
3.2 Warning
The converter plug should not be removed whilst connected to a mains socket.
Disconnect from the mains before proceeding to 3.3

5
3.3 Removal of converter plug
The appliance is supplied with the converter plug fitted over the ‘schuko’ plug
as shown in figure 1.
Figure 2 –As supplied; converter plug fitted
The screws of the converter plug are loosened as shown in figure 2
Figure 3 –loosening of screws of converter plug

6
The top housing is held in place by two barbed inserts. Insert small screw driver
as shown in figure 3 to release the barbed clips.
Figure 4 –releasing of the barbed clips or the top housing
The top housing is then lifted allowing removal of the ‘schuko’ plug,
see figure 5.
Figure 5 - picture showing 'schuko' plug inside converter plug

7
4 Operating instruction
The EC Aura is an appliance to assist cooling by blowing a jet of air. The appliance
shall be connected to a mating mains socket and power turned on.
There is an actuator to turn the appliance on and off on the top of the appliance.
Warning: this does not isolate the mains supply. To isolate the appliance disconnect
the plug and supply cord from the mains supply socket.
When the actuator switch is turn on the speed of the fan and the volume of air moved
is adjusted by rotating the knob on top of the appliance.
The appliance can be titled to angle the jet of air up or down. Warning: ensure the
supply cord does not become jammed.
The appliance can be moved using the fixed wheels. Warning: do not move the
appliance during operation.
5 Maintenance
Electrical Strength Test: the regular high-voltage test must be undertaken with
a DC voltage to avoid damaging internal electronic components.
A replaceable 5 AMP fuse is fitted in the convertible plug.
This appliance contains no user serviceable parts.
Clean only with a damp cloth. Warning: do not jet or power wash.
If the supply cord is damaged return to the supplier for repair or repair using a
suitably qualified person in order to avoid a hazard.
6 WEEE (waste electrical and electronic equipment)
ebm-papst UK Ltd complies with the Waste Electrical and Electronic Equipment
(WEEE) Regulations through membership of a producer compliance scheme (PCS)
as a B2B producer. EEE Producer registration number: WEE/CA0209WR.
7 End of life
This product has been designed to consider re-use and end-of-life disposal. The parts
likely to wear during use, the tilt mechanism, electric motor/fan and speed control unit
are designed for easy repair or replacement. The manufacturer should undertake the
repair of the components, but a suitably qualified and competent person can undertake
replacement of the components, enabling the life of the product to be extended.
If the product has come to the end of its life and it is not practical to repair then the
unit can be easily disassembled for the components to be recycled. The product has
been designed to meet the requirements of the RoHS directive and most of the
materials can be recycled.
Refer to figure 6, 7 and 8 when repairing or dismantling the appliance.
8 Take back policy
As part of our commitment to minimise the disposal of Waste Electrical and Electronic
Equipment (WEEE) customers can return the ec aura at the end of its life. Please
contact us on 01245 468555 for details and issue of an end of life RMA number.

8
Figure 6 - control panel sub assembly
Figure 7 - housing sub assembly
Figure 8 - trolley sub assembly

9
9 Data sheet

10
10 Certificate of Conformity