EcoFlow Smart Home Panel User manual

Installation
Instruction
Smart Home Panel

Introduction
Commission
Wiring
FAQs

EcoFlow Smart Home Panel(hereinafter referred to as SHP) is a smart load side transfer switch,
it can be used as a fast-charging docking station for the DELTA Pro in the grid mode and can switch 10
downstream load circuits between the grid and the backup power station when the power grid goes
down. It also enables the app control so that you can monitor and control these circuits anywhere,
anytime.
Introduction
SHP = Automatic Smart Switch?

Introduction

Commission
Wiring
Introduction
FAQs

Key Points:
1. The current rating of relay modules
should match the upstream circuit breaker.
2. All input wires should be routed through
the lower conduit into the SHP and output
wires through the upper conduit.
Scenario 1
Single Phase
without AFCI/GFCI

Realistic Scenario1

Key Points:
1. All upstream AFCI/GFCI breakers should
be replaced with conventional breakers
and you may connect existing AFCI/GFCI
breakers or use AFCI/GFCI outlets
downstream to SMART HOME PANEL.
Scenario 2
Single Phase with
AFCI/GFCI

Key Points:
2. Ecoflow would provide the AFCI/GFCI
conjunction box(as the right figure) if
AFCI/GFCI breakers are needed on the
loads.
3. AFCI/GFCI conjunction box only support
Plug-in type breakers,
Scenario 2
Single Phase with
AFCI/GFCI

Typo Scenario2