ECOsee ESC-DF700R User manual

Vandal-proof IR Dome Camera
Instruction Manual
Before operating the unit, please read this manual thoroughly
and retain it for future reference.
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

DO NOT ATTEMPT TO DISASSEMBLE THE CAMERA.
Safety Precautions
Risk of Electric Shock, Do not Open
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER NO USER-
SERVICEABLE PARTS INSIDE REFER
SERVICING TO QUALIFIED SERVICE PERSON
This symbol is intended to alert the user to the presence of
uninsulated dangerous voltage within the product's enclosure that
may be of sufficient magnitude to constitute a risk of electric shock
to persons.
This symbol is intended to alert the user to the presence of
important operation and maintenance instructions in the literature
accompanying the appliance.
1
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

3Electromagnetic fields in specific frequency may cause
image interference.
4Be sure to use only the standard adapter which is specified in
the specification sheet. Using other adapter could cause fire,
electric shock or damage to produce.
Incorrectly connecting the power supply may result in fire,
electric shock or damage to produce as well.
6Do not connect multiple cameras to a single adapter. Exceeding
the capacity may cause abnormal heat generation or fire.
7Securely plug the power cord into power receptacle. A loose
connection may result in fire.
8When installing the camera on a wall or ceiling, fasten it safely
and securely. A falling camera may cause personal injury.
9Do not place conductive objects (e.g. screwdrivers, coins, metal
things, etc.) or containers filled with water on top of the camera.
10 Do not install the unit in humid, dusty, or sooty locations. Doing
so may cause personal injury.
11 If any unusual smell or smoke comes from the unit, please stop
using the product. In such case, please immediately disconnect
the power source and contact local authorized distributor.
12 Do not install the unit in humid, dusty, or sooty locations. Doing
so may cause personal injury.
5
2
Warning
1This product has patented for configuration and appearance
design, and copying is not permitted.
2If this product fails to operate normally, contact authorized
distributor. Never disassemble or modify the product in any
way. Problem caused by unauthorized user disassembly or
repairs are out of warranty scope.
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

1Do not drop objects on the products or apply strong shock to it.
Keep it away from a location subject to excessive vibration or
magnetic-field interference.
2Do not install in a location subject to high temperature (over
122°F or +50℃ ), low temperature（below 14°F or -20℃）, or
may cause fire.
3If want to relocate the installed products, be sure to turn off the
power before moving or reinstalling it.
4Remove the power plug from the outlet when there is a lightning
storm. Neglecting to do so may cause fire or damage to the
product.
5Avoid a location which is exposed to direct sunlight, or near heat
sources. Neglecting to do so may cause fire.
6Install in a well-ventilated location.
Cautions
7Avoid aiming the camera directly towards extremely bright
objects such as the sun, as this may damage the CCD image
sensor.
3
Read these instructions
Keep these instructions for later use.
Pay attention that all warnings should be adhered to.
Follow all instruction.
Do not use this product near water.
Clean only with dry cloth.
Do not block any ventilation openings.
Do not install near any heat sources such as radiations, heat
registers, or other product (including amplifiers) that produce heat.
1
2
3
4
5
6
7
8
Important Safety Instructions
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
Only use attachment/accessories specified by the manufacturer.
For added protection for this product during a lightning storm, or
when it is left unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the antenna or
cable system.
Refer all servicing to qualified service personnel. Servicing is
required when the product has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the product has been exposed to rain
or moisture, does not operate normally, or has been dropped.
Do not operate the camera beyond its temperature, humidity or
power source ratings. Operating temperature: 14F-122F（-20℃-
50℃) ;Humidity﹤85%。
Do not point the camera towards the sun; do not operate camera
in a spotlight, highlight, or reflection environment.
9
10
11
12
13
14
4
b) In damp or dusty locations
c) In a place exposed to rain
d) In a place subject to vibration
f) In a place exposed to fluorescent light
e) Near a source of electromagnetic radiation (wireless/radio
or television emission)
g) In a place under poor lighting condition
The laser beam may damage CCD. Do not project the laser
beam directly into the lens of the camera.
16
a) In excessive heat or cold locations
Do not install or use the camera in the following places.
15
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

5
Table of Contents
Chapter 1 Overview ....................................................... 6-8
Instruction
....................................................
6
...............................................
Specification 6-7
.......................................................
Package 7
...............................................
Product Parts 8
Chapter 2 Operating Instruction
.................................. 9-10
..................................................
Connection 9
..................................................
Installation 9
..................................
Before Installation
9
............................
Installing the Camera 10
.......................
Cautions for Installation 10
Chapter 3 Common Troubleshooting
.........................
11
Chapter 4 Current Maintenance
..................................
11
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

Specification
Camera
Image Sensor
1/3" DIS
1/4" DIS
Signal System
PAL / NTSC
Effective Pixel
756(H)× 504(V)
720(H)× 576(V)
Horizontal
700TVL
700TVL
Min.
Illumination
0.1Lux @ (F1.2,AGC
ON),0 Lux with IR
0.1Lux @ (F1.2,AGC
ON),0 Lux with IR
Shutter Time
1/25(1/30) s to
1/15,000 s
Auto
Day & Night
IR Cut Filter with Auto Switch
Sync
Internal
Video Output
1Vp-p Composite Output (75Ω/BNC)
S/N Ratio
> 52dB
> 50dB
BLC
On
Chapter 1 Overview
Instruction
This is a Vandal-proof IR Dome camera. It saves costly
installation time and provides more convenience and functions.
Built-in 3.6mm 1/3” IR 1.3 Megapixel Lens
Built-in ICR
2 Pcs of IR LED Array, Total Power 4W
Visible Range up to 20m/60feet in Total Darkness
3-Axis Vertical/Horizontal/Rotational
Full Metal Body Vandal-proof
Water Resistance IP 66
6
Model No. 1/3” DIS 1/4" DIS
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

Lens
Model
3.6mm IR 1.3MP
Angle of View
70°
Mount
M12
General
Power Supply
DC 12V
Power
Max. 1W (Max. 6 W with IR Cut Filter ON)
Operating
-20°C ~ 50°C
IR Light
2 Pcs of Array LED (2W Each)
IR Range
20m/60ft±3m/10ft
Weather Proof
IP66
Bracket
3-AXIS Concealed Cable Bracket
Dimension
Φ71.4 mm×72.1mm
Weight
260g
*Design and Specifications are subject to change without notice.
7
Check the contents of package. The following items are included.
One User Manual
One IR dome camera
Three fixed screws with dielectrical covers
One dielectrical paper
One L-type screw driver
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

1Fixed Holder—Fixing the camera to the ceiling or wall
2Connecting Ring— Fixing the main housing and the eyeball to fix
the monitoring direction
3Holding Housing — Holding the eyeball
4Eyeball — Main body in which the lens and chipset built-in
5IR LED Array — Providing assisting light source in darkness
6Photovaristor — Automatically photometry to switch the IR LED
Function of product parts
8
1
2
3
4
5
6
Fixed Holder
Eyeball
Photovaristor
IR LED Array
Holding Housing
Connecting Ring
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

1Make sure the installation location can support 5 times the total
weight of the dome camera.
2Be careful not to let the cable be jammed in inappropriate places
or to let the insulation covering of the cable peel off during
installation. This may result in malfunction or a fire hazard.
Make sure that nobody is beneath the installation location, and
remove the camera if anything urgent needs dealing there.
3
Read the cautions before installation:
Installation
Before Installation
9
Chapter 2 Operating Instruction
Connection
1Connect one end of the BNC Cable to the terminals of the monitor.
2Connect the other end of the BNC Cable to the VIDEO OUT
3Then, plug in the power adapter into the power receptacle. The
screen will be displayed when the monitor is on.
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

10
1Allow the cable to pass through the hole in the middle before
mounting the camera to the fixed holder.
2If passing through the side, the cable must be put at the cable
trough first before the camera is mounted.
Installation process is illustrated as below
Installing the Camera
Cautions for Installation:
Step 1: Place the dielectrial paper on the wall/ceiling, which is to protect
the camera from damage by conducted current.
Then fix the fixed holder to the wall/ceiling with 3 screws.
*Pay attention to the cable trough. Put it in the direction of power supply if
cables exit there.
Step 2: Attach the camera body to the fixed holder.
Step 3:Rotate the eyeball to set the monitoring direction according to
actual need in different applications.
Step 4, Fasten the connecting part to finish the installation job.
Cable Trough
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R

Chapter 4 Current Maintenance
1In use of the camera, regularly clean the dust and dirt on the lens
surface of the camera to keep good clarity of image.
2Clean the camera with dry and soft cloth. For stubborn dirt,
please wipe it with a cloth dipped in a little neutral detergent,
and then dry the camera with cloth.
3Be careful not to use volatile impregnant like thinner, alcohol,
benzene or pesticide, etc. to clean the camera, for that can
damage the surface coating, and even weaken the function and
performance of the camera. 11
Chapter 3 Common Troubleshooting
If encounter troubles in use of the bullet camera, please refer to the
following instructions. For more information, please consult nearby
local authorized distributor.
Troubles
Solution
No Video Output
Check the power supply, or the connection among the
cable, camera and monitor.
Malfunction
Check whether the camera is connected to the DC 12V
power. supply
Light Image
Adjust the display contrast of the monitor; Change the
location if the camera is exposed to intense light.
Dark Image
Adjust the Brightness.
The situations below are not malfunction of the camera.
Vertical Streak
It may appear when the camera is exposed to intense
light.
Fixed Image
Clutter
When the camera is in high temperature environment,
there may be fixed image clutter on the entire monitor
screen.
Jagged Image
When shooting at a ribbon-like object, a straight line or
something of similar patterns, the image displayed on the
monitor may be serrated.
http://www.e-camere.ro/camere-supraveghere/ECOsee/ESC-DF700R