EcoxGear SOUNDEXTREME ExtremeTower TBB8 Installation instructions

PLEASE READ
BEFORE UNBOXING
BEFORE you start unpacking your ExtremeTower
Speakers, PLEASE READ this Hardware Guide, then read
the ExtremeTower Speakers Installation and User Guides.
ExtremeTower TBB8 | Models: SEI-ETAMPBAT7700...20
8 inch Tower Speakers
Hardware Guide
Batteries
2
Bluetooth Amplified Tower Speakers
2

2
Hardware Guide
ExtremeTower Packaging Layout
Mounting parts and tools are in the top level and the cables are
located in the bottom level of the protective foam packaging.
Top Level: Mounting Parts and Tools
2
1
3
65
4
7
1. Remote Control (2 pcs)
2. Clamps
· Clamps - Top & Bottom (2 sets)
3. Locking Harness Sets
· Locking Screw Latches (2 pcs)
· Quick Release Knobs (2 pcs)
· U-Shaped Pins (2 pcs)
· Base Cover Plates (2 pcs)
· M3 x 10 Screws (8 pcs)
4. Thick Rubber Insert &
Bolt Sets
· Thick Rubber Inserts (2 pcs)
· Short Mounting Bolts (4 pcs)
· Anti-Loose Spring
Washers (4 pcs)
· Flat Washers (4 pcs)
5. Battery Pack Sets
· Battery Pack (2 pc)
· Battery Wall Charger (2 pc)

3
Hardware Guide
6. Mounting Tools
· Allen Wrench (1 pc)
· Electrical Tape (1 pc)
· Heat-Shrink Tubing (6 pcs)
· Insulated BUTT Connectors -
Blue (6 pcs) & Red (6 pcs)
· 6-pin Deutsch Rubber Plugs (2 pcs)
7. Thin Rubber
Insert & Bolt Sets
· Thin Rubber Inserts (2 pcs)
· Long Mounting Bolts (4 pcs)
· Anti-Loose Spring
Washers (4 pcs)
· Flat Washers (4 pcs)
Bottom Level: Speakers and Cables
2
1
2. Cable Sets
· Aviation Cable Sets (2 pcs)
· Deutsch Cable Sets (2 pcs)
· Power Extension Cables (2 pcs)
· Remote Turn-On Extension
Cable (2 pcs)
1. Speakers
· ExtremeTower Speakers
(2 pcs)
· Aviation Connector Caps
(2 pcs)

4
Hardware Guide
The ExtremeTower TBB8 Set includes two high-powered,
amplified tower speakers, with LED Party Lights and a built-in
LEDCast LED controller.
Important: Do NOT connect this product to any other manufacturers’
LED controller. Connecting this product to any other manufacturer’s
product may cause permanent damage to the product and shall
VOID THE PRODUCT WARRANTY.
BEFORE you start your installations please READ the following
options for power connections, wiring, and mounting.
Amplified Tower Speaker Power Connection Options
There are two power options for the Amplified Tower Speaker:
1. Connect to your vehicle’s battery.
2. Use a removable and rechargeable Battery
Pack. The Battery Pack can be removed
from the speaker and charged via the
Charger or left installed in the speaker
and be charged by your vehicle’s battery /
power. The speaker’s battery will only be
charged by the vehicle when your vehicle
is switched and powered on. When your
vehicle is switched o, the speaker will only
use the battery charge of the integrated
battery and will NOT drain power from your
vehicle’s battery.

5
Speaker Power and Signal Wiring Cable Options
There are two power and signal connection jacks on the speakers:
Deutsch Connector Jacks Aviation Connector Jack
Hardware Guide
1. A round Aviation Connector Jack is inside the speaker’s
Base-Mount.
2. Two square Deutsch Connector Jacks are behind the
speaker’s Base-Mount, behind a rubber cap.
Your speakers include two Cable sets.
IMPORTANT
1. An Aviation Connector Jack Cover
Cap is attached to the Base-Mount
on the speaker.
If you choose to use the Deutsch
Cable Set for wiring, before
installation, you MUST screw the
cap into the connector jack on the
speaker, tightening it clockwise
with a long nose plier (not included)
or similar tool. Failing to do this will result in potential water or
moisture penetration into the jack connector pins, causing damage
to the speaker and VOIDING THE PRODUCT WARRANTY.