ECU Master HALDEX Quick start guide

HALDEX – WIRING DIAGRAM
IMPORTANT !
1) Flyback diode for oil pump control must be conected ! Otherwise the device will fail.
2) Power ground terminal 15) should be connected with separate wire.
3) +12V must be switched power.
4) Use 3A fuse for switched +12V and 10A fuse for Oil Pump power.
5) If you use VSS input, connect pullp resistor to VSS input 10K)
1. +12V 2. LED Out
3. Analog #2 In / Hand brake 4. Pot IN
5. Pot +5V 6. Analog #1 In 7. Switch
8. VSS Input
9. GND
10. Stepper 1 A
11. Stepper 1 B 12. Stepper 2 A 13. Stepper 2 B 14. Temp. In 15. Oil Pump GND 16. Oil Pump Out
HALDE
X
1. Stepper 1A 2. Stepper 1B
3. Stepper 2A 4. Stepper 2B
1. Temp Sensor 3. Temp Sensor Gnd
OIL
PUMP
+12V
+12V
VSS 10K/A
1K
2 1
+12V

Konfiguracja
Fre . Limit to turn off – the frequency on VSS input
that cause controller to set torque transfer to 0%
Fre . Limit interpolation start – the frequency of
VSS input whene the controller start to interpolate of
torque transfer.
Here is the diagram how does it work
Max oil temperature – if the temperature of Haldex module oil is greater that this parameter the
controller switch the Haldex module off, and the torque transfer is set to 0%.
Advanced settings (only for advanced users!)
Step scale – maximum number of Haldex actuator steps
Stepper motor speed – the speed of actuator
Pump ctrl. Fre uency – oil pump control PWM freqency Hz * 10)
Pump DC - oil pump control DC
% torque transfer
Vss freq.
Freq. Limit
interpolation start
Freq. Limit to
turn off

Logged parameters
The device monitors and log the following parameters
Oil temp. - current Haldex module oil temp.,
Re . pos - required torque transfer in %
Curr. Pos – current torque transfer in %
Fre . In - frequenct on VSS input
Analog #2 – voltage on analog #2 input.
PumpDC - oil pump control Duty Cycle,
User switch – state of activation switch